 |
|
| Browse | Ask | Answer | Search | Join/Login |
|
|
||||
|
98 accord stopped running
Was driving my accord down the road at 55mph when it just shut down like somebody turned off the key. Coasted to a stop, waited 5 min. the car started right up. Back on the road a mile down at same speed the same thing happens. Pulled over and again waited a few minutes, can started and idled fine. Called a tow. What could this be
|
||||
|
||||
|
Perform the tests outlined in Sections A and B below:
https://www.askmehelpdesk.com/cars-t...das-46563.html Be sure to check for codes. Also, run the K-Test on the ECM at a number of different times, since you may have intermittent ECM failure. If the ECM consistently passes the K-Test, replacing the main relay, Ignition Control Module (ICM), and coil will likely solve the problem and restore "like new" reliability and performance. These are all problematic components on Hondas. Should you decide to replace the ICM and coil, here's how to do the work yourself: https://www.askmehelpdesk.com/cars-t...tml#post265896 |
||||
| Question Tools | Search this Question |
Add your answer here.
Check out some similar questions!
I'm VERY new at the subject of well water and all that goes into making it happen and need some advice. I'm house sitting for a friend and yesterday the water stopped working. She has a well system with a Franklin 280 107 49 control box, a pumptrol square d 30/50 pressure switch, a well-x-trol...
I have a miller condenser unit, and it stopped running. I hear everything else trying to run, the coils are getting super hot after 2-3 minutes, and the fan will not start running. What could be wrong?
My Janitrol AC Heating unit stopped running suddenly. I can neither use the Cool nor Heat (if I switch to either on the thurmostat I hear nothing). The fan doesn't run either when switched to ON. I checked the cirtcuit braker for the AC/Heating using and it was in the ON position, but when I try...
I have 3 year old GE Dryer that stopped running yesterday. I started a load of clothes with no problems, and went out to get them about 4 hours later. Well, a cord had been laying over the timer switch and it would not let it turn, so the dryer ran the entire time. The dryer was not hot at all,...
Hi, When I switch my thermostat to cool, the furnace fan runs as long as I keep setting at cool, but the condenser stop after about 30 minutes. The fan switch on the thermostat set to Auto. As far as I remember, the whole system should run for a period and then stop for a while (like taking...
View more questions Search
|
