Not your question?
Ask your question
View similar questions
Add your answer here.Check out some similar questions!
New hot water heater installed, but no hot water pressure. Plenty of cold water?
[ 11 Answers ]
Hi, I own a small plumbing service and have a problem I've never encountered before. I installed a new top vented gas water heater for a customer. Turned the main back on, bled air out of the lines, etc. Problem is there is no hot water pressure throughout the house. Cold water pressure is fine....
Bleeding Hot Water Baseboard System
[ 2 Answers ]
I have a gas fired boiler that heats water, uses 1 circulator pump to pump water to 2 zones (each with its own thermostat), using copper pipe to baseboards with fins. I am having difficulty bleeding the air out. One zone heats fine, the other not at all. I think there may be some kind of air...
Hot water baseboard heting
[ 1 Answers ]
How do I bleed Air from a hot water baseboard heeating system?
Baseboard Hot water pipes
[ 1 Answers ]
My house is about 38 yrs old and my hot water baseboard heating system was installed with iron pipes instead of copper. Im renovating part of my house and the iron pipes and fittings are expoxed because I opened the ceiling. The pipes look good with no rust. Im afraid one day they will rot. Should...
Loud banging upon turning off baseboard hot water system
[ 1 Answers ]
Hi - we have baseboard hot water heat. When we go to bed at night we turn down the temperature on the thermostat, so the system shuts off for a bit as it cools down. After a few minutes we start to hear very loud banging or breakng noises coming from mostly one room of the house (our bedroom). ... View more questions Search
|