Not your question?
Ask your question
View similar questions
Add your answer here.Check out some similar questions!
Floor drain for shower
[ 4 Answers ]
Hello I am new to this forum. I have removed a tub shower and I am adding a shower only. I am going to use the Kerdi on the walls and I am looking for some help on the floor drain. I have attached pictures and you can see the drain was not centered so I saw cut the floor. The p trap is presently...
Bad slope in shower floor tile project
[ 2 Answers ]
Sorry if I am double asking... first asked this in Construction and got only one answer... any other ideas in the plumbing section? I just replaced my shower and put in slate tile on floor and walls. I tried to put in a sloped mortar floor before putting in the tile but I did not put enough...
No slope toward floor drain.
[ 3 Answers ]
The crew that did my concrete also forgot to slope the floor toward the drain, then they cut lines in the floor and sawed right through the drain opening. Any suggestions.
I need to slope a floor toward the drain?
[ 1 Answers ]
I have been asked to do a tiel job. The problem is that there is a floor drain that doesn't slope properly. I need to put a small slope on the floor but not too much. The existing floor is concrete. Do I use a Mud bed? How do I get a gradual slope over a large area? Please help.
Converting cast iron floor drain to shower drain
[ 3 Answers ]
I am adding a bathroom to my basement, which has partial (complete? ) plumbing already roughed into the floor (in 1976). Sewage lift station (vented) is 3 ft from 4" styrofoam plug (toilet), 4 ft from 1 1/2 inch cast male pipe end extending through floor (lav, have already added vertical vent... View more questions Search
|