Not your question?
Ask your question
View similar questions
Add your answer here.Check out some similar questions!
Basement tub drain connection
[ 1 Answers ]
I'm getting ready to install a tub on the concrete. The drain line was roughed under the slab, and there is a 10" X 10 " dap box that exposes the drain line. It looks to me that the P trap was not part of the rough. So I'll need to glue a P trap in, and leave the open end pointig up in the right...
Toilet supply/hose bib connection
[ 1 Answers ]
I have two hopefully simple questions. First, where is a good location to connect the supply line for the toilets? I have a mid 60’s split-level and I replaced all the copper supply lines but have not yet connected the upstairs toilets. I heard/read somewhere that the line should be connected at...
Replacing a toilet flange with a lead connection
[ 6 Answers ]
I am about to pull up my old toilet and take a close look at what's underneath. I am also going to go over the original plank sub-floor with fresh 3/8" ply (followed later with thin lauan for eventual linoleum) there is a visible floor patch from an old repair. Given the fact that there has been a...
Tub drain (dap out) connection problem
[ 6 Answers ]
After gutting and remodeling my guest bath I went to install a new tub drain though an access panel I have to the pit in my slab. Reading through the posts I think this is called the dap out. My new tub drain kit came with new pipes so when I went to unscrew the top collar on my dap out pipe,...
Shower to toilet connection
[ 2 Answers ]
Hi, I'm in the process of installing a new shower. The closest drain to it is the closet ell. Can I remove the closet ell and instead use a three inch ell with a 2" heel inlet and drain the shower into this, or will this cause problems. I will install a vent on the shower drain side. Any... View more questions Search
|