 |
|
| Browse | Ask | Answer | Search | Join/Login |
|
|
||||
|
Washer machine mystery
Hi,I have a older kenmore washer part no.3352844 or model 110 4030090,the bottom part of the agitator is working fine but the top part which is supposed to spin the opposite way does not work well,it feels like it is slipping.Upon removing the snap lid I found 4 small plastic parts resting on top of the agitator securing bolt(for lack of a better word)I think they are used to lock in the top part of the agitator allowing the correct agitating motion---my problem is I can not find a correct way to re-install them ,can you help? Thank you very much
Vince111 |
||||
|
||||
|
Cheap and easy fix. Would advise replacing the cams (dogs). Go to ApplianceJunk.com Appliance Repair - Service Manuals - Forums - Videos, there is a video there showing you how to replace. I believe it is of a whilphool which is the same as your kenmore.
[quick=475,325]/video/dogs.mov[/quick] |
||||
| Question Tools | Search this Question |
Add your answer here.
Check out some similar questions!
Is the end of the water exit hose from the washer machine needs to be higher then the top of the washing basin of the machine. Could this connection be made with an air tight assembly that will not be looking more like a cut open pipe with a black plastic hose hanging in it? Thank you. Ps: I...
I have a 70 series Kenmore washer that stopped spinning. It pumps and drains but it won't spin. At first it stopped spinning on all cycles but one. Now it's not spinning on that cycle either. I've checked lid switch and the motor coupler... what next? Mike
I have a 7 yr old washing machine that does not shut off once it is filled up? It sometimes does turn off but recently I have even put it on a small load and the water still runs when it goes into the next cycle? Is it some type of sensor that needs to be fixed? Is it an east task and should I try...
What make and model? Yes, there is a sensor. But we need more info
All right, I live in a mobile home, and my water valves for th ewasher machine are leaking. I bought a new setup up valves that are brass. But I got to look and I have that poly something lines that the water run through. My question is can I use compression fittings to hook the poly lines to...
View more questions Search
|
