Ask Experts Questions for FREE Help !
Ask
    pdean814's Avatar
    pdean814 Posts: 4, Reputation: 1
    New Member
     
    #1

    Oct 3, 2007, 07:13 AM
    Installing new shower pan
    I am installing a new shower pan since there weren't any in my house built in 1985. I was reading various literature and it says before I put in my sloped concrete I need to put down a liner of roofing felt. Do I need to do that over concrete subfloor or just a wooden subfloor? Please help.
    KBC's Avatar
    KBC Posts: 2,550, Reputation: 487
    Ultra Member
     
    #2

    Oct 8, 2007, 05:18 AM
    I am not sure,but here is my 2 cents worth.
    Felt paper will stop moisture from full contact between the concrete and your new pan,mainly the purpose of felt in roofing is for moisture diversion,condensation barrier,etc.

    The heat from hot water in a shower base and concrete flooring will cause condensation so it does make sense to put it down,just my opinion,

    Ken

Not your question? Ask your question View similar questions

 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

My shower drain is raised above the shower pan by 3/16" causing standing water [ 2 Answers ]

I have a fiberglass shower stall where the bottom has either slumped or the stall was installed wrong to begin with (it has no support beneath the surface that I stand on). The drain sticks above the level line so I have about 3/16" of standing water. I cannot easily access the bottom from the...

Installing custom sized shower pan on concrete slab [ 1 Answers ]

I am removing an existing fiberglass shower unit to replace it with a larger, custom-built ceramic tile shower. The subfloor is a post-tension concrete slab. I will not be able to move the drain, so it won't be centered in the new shower floor. I'm Ok with having an off-center drain. But, all...

Installing a washer drip pan [ 1 Answers ]

How do you install a washer pan? This will be on the second floor of an addition. Do I set it on the sub floor and tile around it or do I tile first and set the pan on the tile. I plan on plumbing the 1" pipe through the floor to the first level and then to an outside wall to the out side of the...

Installing new tile on top of shower pan [ 2 Answers ]

I am going to be installing tile over durock cement board which sits on the top edge of my shower pan and just slightly over hangs into shower pan. Should I rest the starter row of tiles down on the cultured marble shower pan which has a 1/2 in lip or should I leave maybe 1/8 gap and if so what do...

Installing new shower pan drain [ 2 Answers ]

I purchased a shower pan drain for my new shower pan. When installing it there is a rubber washer and looks to be a paper washer I set the crome male threaded end through the pan hole then went under home and threaded it onto the under side of the shower pan bottom. Rubber seal first then the...


View more questions Search