Ask Experts Questions for FREE Help !
Ask
    DeniGuti's Avatar
    DeniGuti Posts: 21, Reputation: 2
    New Member
    		  
    #1

    Oct 1, 2007, 11:42 AM
    Water won't drain on 1st rinse/spin cycle
    I have a refurbrished waster. Kenmore 70 washer body, with a whirlpool tub inside. I am having problems with the 1st rinse/spin cycle. The water won't drain out unless I open the lid and close it hard. Other wise the water just sits there. After it finally refills it will work properly on the final rinse/spin and stop. Weird I must say. This happens in all fabric settings. I tried putting WD40 on the lid hinges, but that did not work. What can we do to fix it? Its not in warranty anymore (4 yrs old)...

    Thanks, anyone?
    esquire1's Avatar
    esquire1 Posts: 2,483, Reputation: 209
    Ultra Member
    		  
    #2

    Oct 1, 2007, 01:28 PM
    Is this a direct drive? If so check the coupler between the motor and transmission. If belt driven, It will have 2 belts. Check them, especially the one on the pump>
Not your question? Ask your question View similar questions
 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

Washing machine that stops at spin and rinse cycle, any ideas why? [ 2 Answers ]

This washing machine has been working but the problem is when it gets to the spin and rinse cycle it stops, as if it just soaks in there and the water doesn't drain out. Any ideas what the problem could be and can it be fixable. I don't know much about washing machines, so easy terms would be...

Kenmore washer trouble, Stopping at Rinse/Spin Cycle [ 25 Answers ]

We have a Kenmore 80 series washer model number 110.26862503. It is just over one year old and the wife has had an issue the last month or so. It started that the cold water stopped filling. So I just switched the hoses and went off to buy the inlet valve assembly. I have not had the time to...

Kenmore washer still has water after spin cycle [ 1 Answers ]

I have a Kenmore washer 80 series model 110, After the spin cycle finishes there is still some water in the washing machine. We restart the cycle and then all the water is gone. This doesn't always happen, sometimes it works fine. Any ideas would be appreciated

Water not completely empting from rinse cycle [ 1 Answers ]

Whirlpool washer about 3 years old is not takeing all the water out of the machine during the rinse and spin cycle. Could something be stuck in the pump housing ? What could be the cause .

Maytag washer: drain pipe overflows during rinse cycle HELP! [ 2 Answers ]

:eek: I have a new Maytag washer. (top load). During the drain cycle I hear the water pumping out but then the water comes back and will overflow at the top of the pipe and on the floor. The old washer did not have this problem. We used a snake, draino etc etc. in the pipe. Sometimes it will NOT...

View more questions Search