Ask Experts Questions for FREE Help !
Ask
    frank tompkins's Avatar
    frank tompkins Posts: 1, Reputation: 1
    New Member
     
    #1

    Sep 30, 2007, 02:35 PM
    Toro tractor won't start
    My toro lawn tractor stalled and won't start turns over but won't fire .
    No spark I checked fuses all OK

    Need help
    MOWERMAN2468's Avatar
    MOWERMAN2468 Posts: 3,214, Reputation: 243
    Ultra Member
     
    #2

    Sep 30, 2007, 03:33 PM
    Remove blower housing to gain access to the coil (armature-magneto), remove the small black "kill" wire and see if you have spark. If not then the coil is bad. You can use a business card to set the air gap between the flywheel magnets and coil.

Not your question? Ask your question View similar questions

 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

Toro lawn tractor [ 2 Answers ]

2002 toro garden tractor, 266h, died while mowing.wouldn't re-start. Battery good. Starter good. Ignition switch does nothing. 10 amp fuse blown. Replaced but no help. Think fuse is tied to the PTO system.

Craftsman lawn tractor 19.5 Briggs twin engine won't start. [ 1 Answers ]

Hello, Last time I used this mower was about 3 months ago, ran it out of gas and left It (covered). Tried to start it yesterday after putting in about 3 gallons of new gas And it will crank fine but not start.. I took off the air cleaner and trickled in a bit of gas And it started to run and...

Toro lawn tractor clutch repair [ 4 Answers ]

Hi I bought a used Toro lawn tractor model# 5700. The blade clutch on the engine crank broke. Both wires coming out of it broke off inside the housing. Is there a way to open the clutch up and replace the wires or am I stuck buying a new clutch? Thanks Stew

Old lawn tractor won't start [ 1 Answers ]

Last year I bought an old Wizard riding lawn mower. Its got 12hp, 465 cc, and 38 inch cut. It ran great until, I was mowing, hit a rock, and the mowing stopped there. The battery went dead, so Ive replaced that. Still nothing. Where should I start, to get it to start?


View more questions Search