Ask Experts Questions for FREE Help !
Ask
    lorac's Avatar
    lorac Posts: 7, Reputation: 1
    New Member
     
    #1

    Sep 22, 2007, 04:00 PM
    Magtag Neptune Washer
    I've had my door switch replaced twice on my Neptune washer model #MAH7500aww, it went out again! Is there a way to bypass that switch or is there a new and improved door switch?
    esquire1's Avatar
    esquire1 Posts: 2,483, Reputation: 209
    Ultra Member
     
    #2

    Sep 23, 2007, 09:06 AM
    Normally they last forever. Check an make sure the wires connecting to the switch are on tight when replacing. Loose wires will cause these problems

Not your question? Ask your question View similar questions

 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

Maytag Neptune washer LOUD spin out [ 7 Answers ]

Our refurbished Maytag Neptune washer was so quiet spinning out when we first got it two years ago. Now It is so loud when spinning out, we cannot hear each other talk. What can I do? (This is the same reason we replaced our last washer!) If it matters we do at least 15 loads a week... probably...

Magtag freg [ 4 Answers ]

Hello everyone My magtag freg is not getting cool. When I unplung the freg after some hours when I plug it back up it get cool and stop. Do I need to get freon?

Maytag Neptune washer softner compart not emptying [ 1 Answers ]

I have an approx. ten yr old maytag neptune washer that has a compartment for softner liquid and /or bleach to be dispensed to washer later in cycle. Lately these compartments are not emptying out the liquid completely.. Any suggestions?

Matag Neptune washer stops... [ 2 Answers ]

Help, my matag Neptune Washer Model # mah3000aww Serial #18138894sz Washer is stopping, and not completing a cycle, it also appears that it no longer spins the clothes, it is pumping the water out. I've taken the front off, and am trying to decide if the motor is bad or the motor control...


View more questions Search