Ask Experts Questions for FREE Help !
Ask
    terminator1-2-3's Avatar
    terminator1-2-3 Posts: 1, Reputation: 1
    New Member
    		  
    #1

    Sep 19, 2007, 01:19 PM
    Noma programmable thermostat
    I have tried to replace a conventional lever action mercury thermostat with a new digital programmable Noma thermostat. The problem is when it turns on the heat and fan works fine but when it reaches heating it shuts of but the fan stays on and will not shut off:confused:
    hvac1000's Avatar
    hvac1000 Posts: 14,540, Reputation: 435
    Heating & Air Conditioning Expert
    		  
    #2

    Sep 19, 2007, 11:06 PM
    The model number of your new thermostat,the model number of your old thermostat and the wiring sequence for both will be needed so I can look them up.

    Check to be sure your thermostat is set to automatic instead of on for the blower circuit before you go to all the above trouble. It could be as simple as the thermostat blower switch being ON and causing the blower to run all the time.
    labman's Avatar
    labman Posts: 10,580, Reputation: 551
    Uber Member
    		  
    #3

    Sep 20, 2007, 04:59 PM
    If it is not the on switch or the programing, go the sticky at the top of the forum. Between it and the manual t at should have come with the thermostat, you should find your problem.
Not your question? Ask your question View similar questions
 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

Noma Programmable thermostat [ 14 Answers ]

I have tried to replace a conventional lever action mercury thermostat with a new digital programmable Noma thermostat. The AC works fine but when I turn on the heat, the AC come on then too and not the heat. I have no heat. This was the wiring for the original thermostat: Orange -> Y Red ->...

Noma Programmable 5+1+1 thermostat [ 2 Answers ]

Hi everyone, I just purchased the above mentioned thermostat and connected the wires accordingly. My question is the old mercury thermostat had a jumper to R and RN if I'm not mistaken. The new digital thermostat only asks that the four wires be connected with no mention of a jumper. I...

Noma programmable thermostat [ 3 Answers ]

I have an old carrier thermostat model q674j119 or t874g1790 for my oil furnace and heat pump. I tried to change this with Noma programmable thermostat model 52-2558-8 but everythings not working. This was the wiring for the original thermostat: O -> Orange R -> Red W2 -> White G -> Green C...

Noma programmable thermostat [ 2 Answers ]

We have programmed the thermostat and it always jumps back to another setting. Can you help.

Programmable noma thermostat [ 1 Answers ]

I am changing a York thermostat to a Noma programmable. I have rewired transferring w to w, rc to rc, g to g, y to y . There is a wire jumper on the York that goes from rc to 4. There is no corresponding 4 on the Noma. Does anyone have a suggestion as to where the wire jumper should go if I...

View more questions Search