Not your question?
Ask your question
View similar questions
Add your answer here.Check out some similar questions!
Replace shower Plumbing Valve assembly shower head 2 knobs
[ 3 Answers ]
In a fiberglass corner shower shell. What I have is an old leaking rusted Shower valve assembly. It leaks from the Shower head that is a hand sprayer with a wall mount from the sprayer. It also leaks around the both the hot and cold water wall mount knobs. The cold water knob the sleeve that...
Shower plumbing
[ 4 Answers ]
My shower drain rough in is 1-2 inches from the rough wall in the basement floor It is a 2 in pipe with trap built in . Do I need to raise the shower or tub floor to connect drain to this hole any diagrams would be greatly helpful.
Plumbing vent stack requirements
[ 2 Answers ]
I am re-doing a master bathroom. Currently there are (2) separate vent stacks in the upstairs, for two separate bathrooms. One stack from each bathroom. Can I elimiate one of the vent stacks and simply tie into the other and have (1) vent stack servicing both bathrooms. The master bath had...
Help with shower plumbing
[ 1 Answers ]
I'm trying to find a way to install a shower at my business. There's no floor drain available, but there is a wall drain where a sink used to be. Is there a kit of some sort that utilizes a pump so that I could pump from the shower to the wall drain? Thanks!
Plumbing question for new shower
[ 1 Answers ]
Hi, Looking for some advice on plumbing the drain on a Schluter-Kerdi shower system. I am a pretty confident DIY’er, but almost contracted this out until I found these great web sites! I am replacing an existing 3’x5’ tub with an already purchased Schluter-Kerdi system (which requires the... View more questions Search
|