Ask Experts Questions for FREE Help !
Ask
    mrlakemary's Avatar
    mrlakemary Posts: 1, Reputation: 1
    New Member
    		  
    #1

    Sep 17, 2007, 06:34 AM
    Fan only runs at high
    Help, I have a Harbor Brezze 52 inch ceiling fan that has been running fine for several months now - but no longer. I have a remote (no pull chains) with low, medium, or high fan setting and light on/off setting. The light works fine - but the fan will only run in high or off. I can select low and the fan will run in high. I can select medium and the fan will run in high. I can select high and the fan will run in high. The off button works fine. I am also hearing a significant clicking noise when running in high and I can not see any cause. I have checked the wiring and all my connections look good.

    What can I do??

    Jim
    ceilingfanrepair's Avatar
    ceilingfanrepair Posts: 5,733, Reputation: 109
    Uber Member
    		  
    #2

    Sep 17, 2007, 07:49 AM
    Sounds like a bad capacitor, and since the capacitor is in the receiver, you need a new receiver.

    Ceiling fan remote controls - help and FAQ- Ceiling Fans N More
Not your question? Ask your question View similar questions
 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

Briggs 15.5 hp runs erratic at high speed [ 1 Answers ]

Just rebuilt a briggs engine and it runs at low speed but loopes at high. I have rebuilt the carb. Adjusted the valves etc. It spits some through the carb. I set the valves at .006 in. and.008 ex.

AC fan runs slow, but switch to heat fan runs normal [ 3 Answers ]

The other morning I came into the house and noticed the ac was not working. I turned off the breaker to the unit for a few minutes. Then turned it back on. Went to the thermostat pushed it over to auto and the fan came on but ran very slow. I them turned it off. Then turn on the heat, the fan...

Fan runs but that's all [ 2 Answers ]

Friends Emachines, T2825 running xp home, 512mb ram, nvidia Gforce MX desktop comuter. I turn on surge protector where computer and monitor are plugged into. I hear my fans running, I push power button on computer and nothing occurs. I push and hold - and nothing. I tested psu with Thermaltake...

Briggs & Stratton 15hp runs rough at high speed. [ 2 Answers ]

I have a tractor mover with a Briggs & Stratton 15hp, it runs good at lowest speed only, unless I put it at full speed and full choke, it backfire out the muffler and shuts down at any other speed. I ran through the carb, seems clean unless I missed something, the float was stuck and it would...

Inside fan runs, outside fan runs, but air is not cold [ 8 Answers ]

The inside fan runs and runs, the outside fan on the compressor runs and runs, but only hot air comes out. I sprayed the outside compressor coils with the garden hose to clean them and checked the inside filter. Is there something else I could check? Thanks

View more questions Search