 |
|
|
 |
New Member
|
|
Aug 25, 2007, 07:06 AM
|
|
1999 Altima Knock/Oxygen sensors
Want to know where the Knock Sensor and Oxygen Sensor are located in 1999 Nissan Altima GXE. Has anyone try to replace them? If yes, please share the procedure.
Thanks in advance!
|
|
 |
Cars & Trucks Expert
|
|
Aug 25, 2007, 07:23 AM
|
|
The O2 sensors are located in the exhaust system, before the converter, and the Knock sensor is located near the center of the cylinder head (single white wire).
The O2 sensors and the Knock sensor, if failed or significantly out of range, will turn on the MIL or SES or Check Engine Light.
But they perform different functions. What type of symptoms are you experiencing?
(edit to line #1) The sensors aft of the converter are considered simple monitors and rarely fail as often as the forward O2 sensors, though both can.
|
|
 |
New Member
|
|
Aug 25, 2007, 07:38 AM
|
|
Thanks for your reply! I have been finding my car's "service engine soon" lights on since a last couple of days and was doing some research as Mechanic's estimates are exorbitant. (>$900). But, I think this can be done at a much lower price. I went to Autozone and they found that the two sensors need replacement through the code-reading.
|
|
 |
Cars & Trucks Expert
|
|
Aug 25, 2007, 07:46 AM
|
|
The O2 sensors are fairly straight forward as far as replacement goes.
The knock sensor can be a bear, though.
Maybe not something you'll neccesarilly want to do in the driveway, either one...
What were the codes Zone gave you?
|
|
 |
New Member
|
|
Aug 25, 2007, 11:34 AM
|
|
The codes were P0141, P0325. I read somewhere that the knock sensor would not cause the SES lights on in Altima. Is this a fact with Nissan vehicles... But, if the diagnostics have shown this code, does the knock sensor necessarily need a replcaement. Can it be a kind of false alarm?
|
|
 |
Cars & Trucks Expert
|
|
Aug 25, 2007, 12:21 PM
|
|
Correct. The P0325 will not turn on the MIL. And the P0141 is for the rear sensor heater circuit. Right now, I would address the rear sensor and clear the codes. If the KS is faulty, you'll need a code checker later, to find if it's come back.
That rear sensor is referred to as a catalyst monitor... meaning it checks to see if the converter is functioning. Just make sure if the sensor has to come out your wrench has a good bite on it or it may round off or strip. Good luck.
|
|
 |
New Member
|
|
Jan 11, 2012, 09:31 AM
|
|
I own a 99' nissan altima. My check engine light is now displayed on the information console. I had a diagnostic check done to find that I need to change the rear O2 sensor. My question is do I also need to change the other o2 sensor located on the manifold?
|
|
 |
Uber Member
|
|
Jan 11, 2012, 10:45 AM
|
|
stagordon, no you don't.
|
|
Question Tools |
Search this Question |
|
|
Add your answer here.
Check out some similar questions!
Where are the oxygen sensors on a 1992 Honda Accord
[ 3 Answers ]
I spoke to a mechanic and he said the oxygen sensor is located under the car towards the back of the engine. The manual indicates it is in the front by the exhaust manifold. I'd like to know where it really is.
Thanks
Carl30
Nissan altima knock sensor
[ 2 Answers ]
Would like to know where the knock sensor is on the 95 nissan altima
Not the oxegen sensor but the knock...
Thanks
Oxygen Sensors
[ 1 Answers ]
This questions is related to oxygen sensors on cars-trucks- Does an oxygen sensor detect lack of oxygen underneath the carriage of a vehicle? Is it possible that an oxygen sensor will cause the engine light to turn on because it is working due to the manifold exhaust being cracked? Thanks
Oxygen Sensors
[ 6 Answers ]
I own a 2002 Nissan Maxima. I recently had a "service engine soon" light come on. The car has approx 49,000 miles on it. I purchased a OBDII diagnostic device which said I had a faulty O2 Sensor on "Bank 1, Sensor 2." There are 4 O2 sensors on this car. All have color coded shielding on the...
View more questions
Search
|