Ask Experts Questions for FREE Help !
Ask
    esquire1's Avatar
    esquire1 Posts: 2,483, Reputation: 209
    Ultra Member
    		  
    #1

    Aug 24, 2005, 02:31 PM
    Solenoid
    Can anyone tell me how to test the soleniod for the reversing valve on a heat pump? :confused:
    tkrussell's Avatar
    tkrussell Posts: 9,659, Reputation: 725
    Uber Member
    		  
    #2

    Aug 24, 2005, 04:35 PM
    You can use an ohm meter to test for continuity of the coil. You should have a certain amount of resistance. If the meter indicates no resistance, then the coil is open, and it will not pull in.

    Be sure the power is of to the unit, and disconnect the two solenoid coil wires to gain access for this test.

    If the resistance is very high, then it still is open .

    You may be able to determine the typical resistance if you can find the manufacturer and check their website for technical data.

    Or if your up to it, you can disconnect one wire, energize the coil, and test the disconnected wire coing from the coil for voltage with a vlotage tester. If no voltage, then the coil is open.
    labman's Avatar
    labman Posts: 10,580, Reputation: 551
    Uber Member
    		  
    #3

    Aug 24, 2005, 07:44 PM
    Another test would be to have somebody switch the system while you check the valve. You should be able to hear or feel it activate.
Not your question? Ask your question View similar questions
 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

Solenoid valve in refrigeration system [ 6 Answers ]

HI I have a question about Refrigration system that has two evaporator in one line, and each one has solenoid valae. What I want to know, why each one has solenoid valve, what is the purpose of that?

Bad solenoid in lawn tractor? [ 2 Answers ]

I was installing a new solenoid in my lawn tractor. The new solenoid posts were bigger than the eyelets in the cable connections. I drilled them out a bit. While tightening the cable connections onto the solenoid the posts in the solenoid began to spin... did I ruin the solenoid?:(

Alternator solenoid valve fuse blowing with 1990 Honda Civic [ 0 Answers ]

A frined (I guess you could cal him that) gave me a 1990 Honda Civic that doensn't run... two problems: one problem is that the fuse to the alternator solenoid valve blows when I turn the key to start thus I can't get the codes from the EUC.. the other one is that there is no fuel getting into the...

View more questions Search