 |
|
| Browse | Ask | Answer | Search | Join/Login |
|
|
||||
|
The design of a down light that is such the light is "cutoff" by the perimeter walls of the housing, complimented by a reflector that "pushes" light down. This is to utilize the lumens more efficiently , and to prevent light trespass beyond the property line.
|
||||
| Question Tools | Search this Question |
Add your answer here.
Check out some similar questions!
I'm a music dj, I have a circuit box with 8 channels that say I can put 10 amps per channel. The box says I can it has a 15amp breaker. The question I'm asking is can I put a total of 80amps since I have 8 plugs?
My builder has put 14 lights on one switch in our new family room. He says that this is OK per code as it only matters how many watts run through the switch. It has a dimmer but I'm still concerned about the number of lights being on at one time using lights that I do not need and the plate gets...
I apologize in advance for my lack of knowledge. In my basement I currently have a single 20A circuit with 6 lights on it, rated at 150W each, controlled by a single light switch. I'd like to know if its possible to break these lights up without adding circuits. Is it as simple as adding a...
I currently have two hanging lights in my office, that both run off the same switch. I would like to change these to one small(3) track light, using the second light box (farthest from the switch). How do I remove the first one? Can I just cap off the wires? Will the switch still control the...
View more questions Search
|
