Ask Experts Questions for FREE Help !
Ask
    dkb072's Avatar
    dkb072 Posts: 7, Reputation: 1
    New Member
     
    #1

    Aug 9, 2007, 03:43 PM
    Exterior fan stops
    I replaced the capacitor and fan motor and I still have a problem with the fan stopping after about ten minutes. All the wiring is correct and the fan spins in the correct direction. The start thermistor gets extremely hot. The compressor continues to run without a problem. The fan will run again after about 10 minutes of cooling. I'm baffled. Please help !
    acetc's Avatar
    acetc Posts: 1,004, Reputation: 79
    Ultra Member
     
    #2

    Aug 9, 2007, 03:48 PM
    Did this problem just start or was something done to this unit in the way of repairs? Is the wiring connected right? Are the wires loose or burnt?
    How is the fan motor wired , some times they wire a little differently.

Not your question? Ask your question View similar questions

 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

Exterior A/C Fan is Erratic [ 1 Answers ]

I have a 21 year old Carrier single phase a/c unit. I did the kick start test on the fan blade and it began to spin as if there was nothing wrong. About 20 minutes later the fan stopped on its own. I pulled the cover off and checked for voltage at all of the terminals and all seemed to be O.K. ...

Why ac fan spins but it stops right away [ 2 Answers ]

When I turn the ac unit on. The fan would spin for a few seconds but it would stop spinning, but the ac unit is still running

A/c fan stops [ 7 Answers ]

I have an older model Fedders A/C unit in my window. When I turn it on the compressor turns on but no fan. If I give the fan a push the fan starts and stays on for about 30min or so. Then the fan stops blowing. I turn the whole unit off. If I wait a couple of hours then I can turn it back on and it...


View more questions Search