Not your question?
Ask your question
View similar questions
Add your answer here.Check out some similar questions!
4-piece shower install
[ 1 Answers ]
I am getting ready to attempt this for first time with a Kohler/Sterling unit. It does not mention the use of a mud base. Is this needed? Any earlier post here talks about using a rubber material to prevent squeaks. Is green board the type of material to finish the top areas. The...
New Shower Install
[ 3 Answers ]
I am installing a new Shower in a two piece bathroom. Can I tap into the existing Hot and Cold from the sink or will this rob me of the pressure I will need. I am running at 60 psi off a well pump. The bathroom is 25 feet away from the pump.
Basement Shower Install
[ 1 Answers ]
Hello, I'm installing a bathroom in my basement. It was originally roughed in for a toilet and sink, of course, we want a shower as well. The shower will go close to where an existing floor drain was, so I dug up the floor and took out the old floor drain trap, y'd the line and put in a new...
New shower install
[ 3 Answers ]
I want to install a shower in a room next to where there is an existing toilet and sink. My question is on venting the new shower. I have access to the basement area, can I hook up the shower drain to the existing sink drain in the basement area. Will this properly vent the new shower? The...
Best way to install fixed shower head and personal shower
[ 4 Answers ]
I am installing a new shower setup. I want to install a fixed shower head as well as a hand held personal shower with hose. On the Kohler website they sell a diverter valve with some sort of backflow valve for this purpose. I have a friend who just had this done and he has no diverter valve just... View more questions Search
|