Ask Experts Questions for FREE Help !
Ask
    transwizard's Avatar
    transwizard Posts: 4, Reputation: 2
    New Member
    		  
    #1

    Aug 3, 2007, 08:31 AM
    John deere 160 garden tractor
    Replacing the tractror drive belt
    esquire1's Avatar
    esquire1 Posts: 2,483, Reputation: 209
    Ultra Member
    		  
    #2

    Aug 3, 2007, 09:00 AM
    Remove the belt guide from the trans. Loosen the idler plate and remove the belt guide and the jacksheave at engine. Put belt around the trans pulley. Around the 2 idlers and back around the jacksheave pulley. Note how they route around idler, flat side of belt around flat idler and tapered side (or inside) of belt to the notched idler.
    transwizard's Avatar
    transwizard Posts: 4, Reputation: 2
    New Member
    		  
    #3

    Oct 3, 2011, 12:25 PM
    Thanks for the help I did not find anything initially and figured it out myself. First time back at site and your info is exact thank you
Not your question? Ask your question View similar questions
 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

John Deere LT160 lawn tractor [ 8 Answers ]

My lawn tractor (LT)will not start. When it is on choke it just acts like it is not getting fuel. When on run when I try to start it it backfires and will not start. I checked the fuel filter, chenaged the spark plug, made sure the carborator was not clogged cleaned out the carborator bowl. The...

John Deere 160 [ 2 Answers ]

I took the floating deck off, when I put it back on, it will not move. I have an owner's manual, but it's no help. Does anyone know where I can get a diagram of how to reattach the deck? THanks, AWE

How do I fix a belt on a old John Deere lawn mower 160 [ 1 Answers ]

The belt while mowing snapped in half. I do not have the owners manual since the mower is over 20 years old. Please help

Bought john deere tractor [ 3 Answers ]

I bought a very expensive john deere x748 loader/mower. It runs on diesel. MY question is can I get this registered to drive down the street to the gas station without going through big hassles at te registery? I can cut though psrking lots except for fifty ft

John Deere LT 160 runs only with choke open [ 3 Answers ]

Rider mower worked OK and then I did end of season service including new spark plug, lube of mower deck, oil change and sharpening blades. It sat idle for some weeks during this and when put back together would run only if choke is semi open. Stalls when set to run position. Have drained tank and...

View more questions Search