Ask Experts Questions for FREE Help !
Ask
    Robert Moran's Avatar
    Robert Moran Posts: 1, Reputation: 1
    New Member
     
    #1

    Jul 28, 2007, 09:48 AM
    Ceiling fan
    I have three wires coming from the ceiling; white, black, copper. The fan has black, white,green and blue. I've connected the black, white and green. But the fan still doesn't work. Any Ideas?
    Stratmando's Avatar
    Stratmando Posts: 11,188, Reputation: 508
    Uber Member
     
    #2

    Jul 28, 2007, 09:59 AM
    Leaving blue wire disconnected OK, if not using light. Check pullchain and direction switch not in middle. Check breakers, and switch, if any.
    ceilingfanrepair's Avatar
    ceilingfanrepair Posts: 5,733, Reputation: 109
    Uber Member
     
    #3

    Jul 30, 2007, 12:28 PM
    Do you have a voltmeter?

    Correct wiring would be white to white, black to black, green to ground, and blue to black if you're using a light.

    Ceiling fan wiring - Ceiling Fans N More

Not your question? Ask your question View similar questions

 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

Hampton Bay Remote Ceiling Fan - light works - no fan [ 2 Answers ]

After about 4 months of use, this began to happen. I would try to turn on the fan (either Low Med or High) and the fan would barely turn. Sometimes it would work - this lasted for about 5 days. Since then, if you try to turn on the fan, you get no response. Now, the light will still turn on...

Ceiling fan wiring, 2 blk, 2 what, 1 red, 1 grn from ceiling [ 3 Answers ]

I am attempting to install a hampden bay minuet 2 fan. The prexisting ceiling wires consist of two black, two white, 1 red, and my ground wire. A basic lite fixture was installed previously and controlled by a single wall switch. The wall switch has 1 red on the bottom and two black on the top...

Hampton Bay Ceiling fan: fan speed pull chain [ 2 Answers ]

The pull chain controlling the fan speed snapped off inside the unit. How much disassembly is required to replace it?

Trouble with ceiling fan on a dual fan/light dimmer switch [ 1 Answers ]

I just installed a new Harbor Breeze ceiling fan and dual fan/light dimmer, also from Harbor Breeze. Unfortunately, now I'm scratching my head... Do I have a bad dimmer switch? Here's the problem: 1. The light will turn on only when the fan speed on the wall switch is set to high. 2. When...

Hanging ceiling fan from vaulted ceiling peak [ 2 Answers ]

Want to install Hampton Bay's Berlini model 729395 on a cathedral ceiling with a single ridge beam. Want to hang fan from the peak and there's not enough room for the canopy to cover the hanger bracket. Is there any extenders for this?


View more questions Search