 |
|
| Browse | Ask | Answer | Search | Join/Login |
|
|
||||
|
Kenmore washer starts to spin then stops
I have a Kenmore washer Model 110.92583100 serial CD2411995 it will start to spin at low speed for about 10 to 20 seconds, then it will stop. If I leave the switch on there will be a 3 or 4 minute delay and it will start again for the same amount of time. I put a new centrifugal switch in because the old one was in bad shape. It did not help. I am suspecting the high speed winding of the motor is bad. Any ideas? Should I buy a new motor? Or scrap it I am not sure how old it is
|
||||
|
||||
|
|
||||
| Question Tools | Search this Question |
Add your answer here.
Check out some similar questions!
My top loading Kenmore washer model 110.92588210, direct drive, runs for 10 seconds and stops for a minute then starts and stops for longer than one minute, this continues and the stop time gradually increases with every restart. No matter which cycle I choose. There is no problem filling with...
Kenmore washer dryer combo 110-92966-102, The washer will fill and it will agitate for a little bit for about a minute, then it will stop before finishing.When it stops there is no motor sound.No matter what I set the knob to it will not start up again,but if I wait several minutes it will...
I have searched everywhere but haven't been able to find an answer to this one. My washer is only about 3 yrs old. It runs through the cycles just fine but when it tries to click over to the spin cyle you can hear the motor running but it does not spin. I lift the lid and I and about 1 second...
My 2 or 3 year old Kenmore washer suddenly stopped spinning! It goes through the entire cycle then suddenly stops at the spin cycle. It makes plenty of noise as if it is was the spin cycle but then when you go to unload the clothes, they are sopping wet. Yet they are not standing in water. The...
View more questions Search
|
