Not your question?
Ask your question
View similar questions
Add your answer here.Check out some similar questions!
Return Air vent sucking air... and being really loud about it
[ 5 Answers ]
In the middle of our living room is a return-air vent. It goes straight up to 2 of the bedrooms upstairs also. When the furnace kicks on, the noise coming from the vent down here is rediculously loud, almost to a point where nothing else is distinguishable above the wind sound. The furnace's...
Return Air Vent installation
[ 1 Answers ]
I am finishing my basement which is 330 sq ft. and surrounded by 3 walls of foundation and 1 wall that is the garage. I will be tapping into the existing AC unit for the supply vents, but was wondering about the need and placement for a return air vent. Is one needed, and if so where should the...
Boiler air vent
[ 1 Answers ]
I'm installing another zone to my force hot water (baseboard) boiler. The initial installation has a shutoff valve and plug on supply and return so extra zones can be installed. On other multizone houses, I've noticed that each extra zone has an automatic air bleed valve on the high point of the...
DW Vent or Air Gap loop?
[ 1 Answers ]
:confused: Hello - I have a DW that is vented and then runs to just below the double sink opposite the disposal. I want to install a new faucet and would like to make a Looped air gap rather than use the vent on top of the counter. Do I have to loop it through the disposal or could I just go with...
Basement return air vent
[ 2 Answers ]
Carrier, modal 58MAC120-20, direct air forced air furnace, seven years old in a 2,700 square foot home seven years old. The basement is 1,200 square feet, open and half finished, has two supply air regesters and no return air vent. What size "opening" is recommended for this area? View more questions Search
|