Ask Experts Questions for FREE Help !
Ask
    birdseye's Avatar
    birdseye Posts: 5, Reputation: 1
    New Member
    		  
    #1

    Jul 20, 2007, 08:34 AM
    Knockout holes
    I've discovered that I have a plastic 2-gang switch box with a knockout that has been punched out but no wire coming through. Is there any remedy short of replacing the box and rewiring the switches?
    hvacservicetech_07's Avatar
    hvacservicetech_07 Posts: 1,083, Reputation: 75
    Ultra Member
    		  
    #2

    Jul 20, 2007, 07:53 PM
    There are caps made just for that, visit your local electrical supply house, let them know what size the hole is and they should be able to set you up.
    Stratmando's Avatar
    Stratmando Posts: 11,188, Reputation: 508
    Uber Member
    		  
    #3

    Jul 21, 2007, 12:15 PM
    Are you talking about square holes?
Not your question? Ask your question View similar questions
 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

Design of a vapor-liquid separator (or flash drum, or knockout drum) [ 2 Answers ]

A vapor-liquid separator drum is a vertical vessel into which a liquid and vapor mixture (or a flashing liquid) is fed and wherein the liquid is separated by gravity, falls to the bottom of the vessel, and is withdrawn. The vapor travels upward at a design velocity which minimizes the entrainment...

Rust holes [ 1 Answers ]

Can you fix rust holes in frame near rear wheelwell on a 1994 honda civic ex

Drilling holes [ 2 Answers ]

I need to drill a4" vent hole for a water heater in side of my house to connect the venting. What is the best drill to use and any avice on problems imight run into?

Green Lee Slug O Buster Knockout [ 4 Answers ]

Has anyone out there used this knockout to punch a hole in a 18 gauge stainless steel kitchen sink? Thank you...

View more questions Search