 |
|
| Browse | Ask | Answer | Search | Join/Login |
|
|
||||
|
Diverter stem replace
I Already Change The Diverter Stem On My Bathroom Shower. I Installed A New One (sayco). It Works Ok, Except When I Rotote It To Change And Send Water Only On Top Shower, Because It Send Also Water To The Bottom Shower (both ways). Do It Have Any Particular Way To Install It? Do I need to change something else?
|
||||
|
||||
|
If the diverter washer and seat's OK then perhaps there's something lodged in the diverter seat preventing it from seating. Did you run water through the open valve body to flush it out before you reassembled it?
If all else fails you could change your spout to a diverter spout and leave the diverter set on tub fill and work off the diverter in the spout. Good luck, Tom |
||||
| Question Tools | Search this Question |
Add your answer here.
Check out some similar questions!
I'm working on old apartment building.. trying to replace old sayco diverter stem.the newer one I bought at a plumbing house look like a perfect match but when I install part of the water still flows out tub spout when it is diverted to shower.. not many moving parts... hard to see where problem...
I have a three handle shower/tub and I recently replaced the inner seat and diverter stem.The problem is that when I open the shower(upper part),water still comes out the bottom spout.I have applied teflon tape plus taken apart the diverter stem and all seems good.I have unscrewed the diverter with...
My home is over 30 years old. I recently purchase new tub/shower handles for an upgrade project. I had no problems until the diverter stem broke. I purchase a diverter stem and it fits except the stem is too short. I cannot find a diverter stem that is the right diameter and length. Is there a...
After I get the knob and bonnet off how do I get the stem off? I've already stripped the darn thing and am frustrated.
I am replacing seats and stems in tub/shower. The old one is Sterling--the new faucet set it a PricePfister. The PF diverter stem doesn't fit into the seat (the hot and cold stems do). Can I go to another size diverter with PF?
View more questions Search
|
