Ask Experts Questions for FREE Help !
Ask
    mez's Avatar
    mez Posts: 2, Reputation: 1
    New Member
     
    #1

    Jun 13, 2007, 10:21 PM
    Blocked pipe or cistern issue?
    Hello, hoping someone may be able to point me in the right direction!
    Old aussie toilet, from the '60s. 2 nights ago when flushed, it flushed fine, then the water rose very high up in the bowl, and took ages to get back to normal level. Tried plunging it last night; same deal. The pipe goes straight into back of wall. The previous owners did internal renovations, and hardi-planked the dwelling - I can't find the pipe outside! Not much room underneath house to go looking; almost ground level here. Am on stumps. Does this sound like a blockage in the pipe, beyond the pan? Do I need a plumber seeing as I can't find the pipe outside? Should I get a plumbers snake and try... something? The shower is in another room, but seems to be fine. I'm not very technical (or confident with things like this!). Any suggestions please? I'm willing to try what I can up to a point!
    speedball1's Avatar
    speedball1 Posts: 29,301, Reputation: 1939
    Eternal Plumber
     
    #2

    Jun 14, 2007, 04:31 AM
    I have one that most repair plumbers miss.. Look down at the bottom of the bowl. If there is a small hole, then that is a jet that starts the syphon action. If it's clogged the water will just swirl around and slowly go down leaving solids behind. Take your finger,(UGH! ) and run it around the inside of the opening. Over the years minerals build up and cut down on the syphon (flush) action. If it is rough or you feel build up, take a table knife and put a bend in it to get around the curve in the bowl and chip and scrap it clear. Next take a coathanger and clear out the holes around the rim. They start the swirling action. And last, check the water level in the tank. It should be 1/2" below the top of the over flow tube. And speaking of the overflow tube, Make sure the small 1/8" tube from the ballcock to the white overflow tube is connected so it discharges in it and that it's flowing when the ballcock fills. This is what raises the water level in the bowl. For a good solid flush they all have to work together. Hope this helps but if it don't click on back and we'll explore other possibilities Tom
    mez's Avatar
    mez Posts: 2, Reputation: 1
    New Member
     
    #3

    Jun 14, 2007, 03:36 PM
    Thank you for your reply; I certainly will try that! We tracked the block back to the kitchen sink; must be right near the junction for the toilet pipes? With a special plunger for the loo, and some draino in the sinks, we managed to clear it, all sinks run well now and loo flushes fine... but seeing how its an old house, I certainly will try your suggestion to keep everything A-Ok! Thanks again :)

Not your question? Ask your question View similar questions

 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

Toilet Drain Pipe Issue [ 4 Answers ]

Hi, I removed my toilet today, as part of remodeling the bathroom. The flange was damaged, but it was also seemingly a part of the pipe underneath. I managed to mangle the pipe in removing the flange. I got under the house and the pipe is connected directly to the cast iron, but is not cast...

Drain pipe angle issue [ 1 Answers ]

I recently purchased a old (1900) 3-family home and during the inspection, it was noted that the drain pipe in the basement went "uphill" in one section. This issue was never resolved. At this point in time, the first floor tenant has begun to complain that when the tenants on the top floors...

Copper Pipe Weighty Issue [ 23 Answers ]

I need to place a 3/4" L copper pipe vertically about 15' and rest it on the decking as I cannot make any wall attachments. It will go over the top railing and secure at that point. I could put a little weight on the railing but not very much and how would I share the load anyway. The pipe will...

My first house... And already a (big) issue -- stack pipe [ 13 Answers ]

My wife and I just purchased our first house last Wednesday and moved in the next day... it's 78 years old and in the city... Well, there were some issues to begin with... a 78 year old toilet to fix the internals on and some under-sink drain plumbing to do... but I got all of that done fairly...

Blocked central heating hot water pipe [ 2 Answers ]

Hi, Hope someone can help me out. A brief senario: the hot water comes out of the boiler and then goes through a pump. After this it get split up 2 ways (1) to the radiators which are hot, working and not the problem. (2) The problem path is through a hot water to water heat exchanger tank...


View more questions Search