Ask Experts Questions for FREE Help !
Ask
    n2space's Avatar
    n2space Posts: 1, Reputation: 1
    New Member
    		  
    #1

    Aug 19, 2007, 10:52 AM
    Pulley 14.5 hp murray
    I need to remove a belt pulley on my riding mower. I got the big nut off, but I don't know if the pulley is threaded on the shaft or pressed or just goes on the shaft. I've tapped it with a hammer, but I can't get it to budge.


    Thanks for any help.
    MOWERMAN2468's Avatar
    MOWERMAN2468 Posts: 3,214, Reputation: 243
    Ultra Member
    		  
    #2

    Aug 19, 2007, 01:57 PM
    The pulley is not actually "pressed" on so to speak, try spraying with a good penetrating oil, then put the nut back on the bolt(shaft) and turn it down to where the shaft is just below the top of the nut and strike with a hammer.
Not your question? Ask your question View similar questions
 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

'88 GMC AC pulley removal [ 6 Answers ]

My buddy has a 88 GMC pick-up truck and his AC pulley seized up. Any help on pulling this out?

B&s 14.5 HP - Drive Pulley [ 1 Answers ]

The keyway is gone, when I try to loosen the bolt, the engine turns. How do you remove the bolt in question when you do not have impact tools available?

Changing Engine Pulley? [ 5 Answers ]

I have Sears riding Lawn Mower with Brides & Stratton engine and it's engine pulley broke off. There are two pulleys attached to this shaft. How to remove and replace this shaft? It's attached to the engine. Thanks.

View more questions Search