Not your question?
Ask your question
View similar questions
Add your answer here.Check out some similar questions!
Copper Cast Iron & Orangeburg
[ 3 Answers ]
I'm adding a room to the house that requires footers. In the course of digging the footers I found my sewer line. Not a problem except that it is Orangeburg style pipe (tar paper tube). Before I build over it, I want to replace that section then eventually replace the whole line to the street....
Copper Pipe Weighty Issue
[ 23 Answers ]
I need to place a 3/4" L copper pipe vertically about 15' and rest it on the decking as I cannot make any wall attachments. It will go over the top railing and secure at that point. I could put a little weight on the railing but not very much and how would I share the load anyway. The pipe will...
Broke off copper pipe
[ 4 Answers ]
I was trying to replace a bathtub faucet and broke off the copper pipe at the wall is there a way to fix the pipe without calling a plummer or soldering?
Copper pipe in the slab
[ 5 Answers ]
In moving our kitchen to another part of the house, I discovered (after removing the old floor cabinets) that the plumbing seems rather "unusual". The 3/4" lines comes out of the floor (slab) to go up to the old sink, but then cross over above the slab about a foot before then going down again...
PVC to Copper Pipe
[ 3 Answers ]
I am remodeling a bathroom. The existing drain pipe is 1 1/2" copper tubing. What is the best way to connect a 1 1/2" PVC to 1 1/2" copper tubing? View more questions Search
|