Ask Experts Questions for FREE Help !
Ask
    spigwead's Avatar
    spigwead Posts: 1, Reputation: 1
    New Member
     
    #1

    Jan 19, 2006, 09:22 AM
    Crown molding
    Question 1 What type of nails do I use for the real wood crown molding?
    Question 2 How do I measure the angle, in degrees, of my ceiling? It is something other than 90 or 45? I was hoping to use something simpler than Trig functions.
    RickJ's Avatar
    RickJ Posts: 7,762, Reputation: 864
    Uber Member
     
    #2

    Jan 19, 2006, 09:40 AM
    I use an airgun for crown moulding.

    As for the angle, it would be 45 degrees - unless vaulted.
    glavine's Avatar
    glavine Posts: 895, Reputation: 87
    Senior Member
     
    #3

    May 20, 2007, 07:23 PM
    The Nails U Need To You Should Be No Shorter Than 2 1/2 Air Gun Nails,
    A Standard Inside And Outside Miter Are 45 Cuts.
    Remember You Have To Cut Crown Upside Down And Backwards, And Bed It In The Mitersaw Correctly, Good Luck Nichols Trim
    Clough's Avatar
    Clough Posts: 26,677, Reputation: 1649
    Uber Member
     
    #4

    May 20, 2007, 09:26 PM
    Thanks for people who are trying to help by posting an answer to the question.

    I hope that people posting an answer to this have noticed the date on the original post.

    I would think that the original poster has probably already found an answer to their question.

Not your question? Ask your question View similar questions

 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

Crown molding [ 16 Answers ]

I need help installing crown molding. Is it necessary to use adhesive as well as nails?

Crown lengthening necessary? [ 23 Answers ]

I had a root canal on Fri and went back to the dentist on Mon for a temp crown and fitting for a permanent crown. The dentist took out the temp crown that the endodontist had used and grinded away most of my tooth. After that, she drew me a diagram, told me that I needed a crown lengthening and...

Crown molding [ 6 Answers ]

I need help to cope a inside 45 on crown molding

Tough molding cut [ 2 Answers ]

Maybe this is possible? Trying to run molding horizontal along the top of tile above a shower surround and match it with a piece running vertical along each side of the shower. These are 90 degrees from each other on each plane - any trim carpenters out there that can help me with these cuts? Don't...

Pain under a crown [ 3 Answers ]

I have a long established crown It has started to give pain The dentist says there may be a cracked tooth underneath With an infection He also says I would lose the tooth if he took off the crown Is there anything I can take to deal with a possible infection?


View more questions Search