Not your question?
Ask your question
View similar questions
Add your answer here.Check out some similar questions!
How to solder tail pipe onto drain pipe
[ 2 Answers ]
I have a 1 1/4" drain on my bathroom sink. It goes into the wall and soldered on to a cast iron elbow. My chrome pipe is leaking and needs to be replaced. What alternatives do I have besides tearing the wall down to repipe?
Kitchen s-trap slipping off tail pipe
[ 4 Answers ]
I have a double kitchen sink with a single s-trap. The problem is that the entire s-trap assembly keeps sliding into the pipe in the floor and sliding off the tail of the pipe coming off the sink. I have tried tightening all the connections. Using different gaskets/washers. Switching from pvc to...
Need washer drain pipe installed, now washer stand pipe is backing up.
[ 3 Answers ]
I've had to route my washer drain out of my septic system (drain fields are bad). In the house crawl space the washer pipe 2" pvc came through the floor one bend (elbow) and 3' of travel to the septic cast iron pipe down to the septic tank. I cut into the pvc just past the elbow (maybe 2' past)...
Copper Pipe Compression Fitting
[ 7 Answers ]
I'm installing a dishwasher, I've never had one before so I am making all new pipe connections. I'm trying to add a t-fitting and then a valve to a copper water line to be able to turn off the dishwasher water supply while still being able to use the sink. I was told a T-compression would work. ... View more questions Search
|