Not your question?
Ask your question
View similar questions
Add your answer here.Check out some similar questions!
What size laminated beam do I need to span 20' for my basement beam?
[ 8 Answers ]
I have a one story ranch and want to eliminate the columns in a section of my basement. The beam will need to support the 2x8 floor joists which are 12' 6" from column to wall. What size beam will I need?
I beam size to carry a 250 ton load. Its 5 feet long and the load is in the middle
[ 3 Answers ]
The 250 ton load is being applied to the center of a 2" thick plate 60" long and 48" wide by a hydraulic cylinder. The 2" plate has a 12" hole in the middle. I want to weld two I beams lengthwise along the 2" plate (one on each side) with bracing going across between the two I beams. The cylinder...
I beam size to carry a 250 ton load. Its five feet long and the load is in the middle
[ 0 Answers ]
Thanks for your reply ebaines. The 2" plate is part of a support base for a casing jack which is used to pull pipe out of the ground. The hole is where the pipe comes up through the base.The hydraulic cylinder that is used to pull the pipe is actualy a hollow cylinder that sits over the hole...
Beam size to replace load-bearing wall
[ 13 Answers ]
Okay, I'm trying to decide if it's worth the trouble to open up a room in my basement. It is currently a 16 ft wide wall with a single doorway in it. It is a load-bearing wall. I'd like to open up the doorway to about 10'6" width. The wall supports the floor above, and there is another...
What size lam beam header is needed to clear span a 30 feet?
[ 2 Answers ]
The beam is needed in a 30x40 garage. We are using trusses that are speced to clear span 40 feet but want the extra support in the center. View more questions Search
|