Not your question?
Ask your question
View similar questions
Add your answer here.Check out some similar questions!
Variable speed blower on AE6015 air handler
[ 3 Answers ]
Going to low fan to high fan back to low fan back to high fan within 3-4 minutes known as heaving.
Variable speed on York Air Handler
[ 1 Answers ]
I have a york air handler (no heat pump) and I have the motor on low (just have to move a wire to change from L,M,H) I was wondering if changing the motor speed to Med or High might help move the air better and make up for better efficiency and help not to be so cold in here at night. I just...
Retrofit variable speed fan motor into air handler
[ 1 Answers ]
I have separate independent heating and cooling systems: oil-fired HW baseboard heat and central air. I presently close off the AC vents in the winter to avoid downdraft from the attic-based ducting system (whole AC distribution is in attic). I've heard that it would improve efficiency and...
Replace air handler with variable speed
[ 1 Answers ]
I want to know if I can replace a standard air handler on a 5 ton system with a variable speed air handler without replacing the outside unit. The electronics on the air handler will be different but does the compressor work full time or not.
Prob. Variable Speed Air handler
[ 2 Answers ]
A Trane XL14i heat pump was installed 6/8/05. The variable speed air handler fan only runs at full speed or off, but not slow when demand is low. The dealer's tech has replaced 2 electronic modules, to no avail. He can't seem get expert advice from Trane. I would greatly appreciate any advise to... View more questions Search
|