Not your question?
Ask your question
View similar questions
Add your answer here.Check out some similar questions!
Capacitor on a ceiling fan
[ 10 Answers ]
Hello everybody. Newbie on this forum. My ceiling fan is out of order due to capacitor burnout. It is 2.25 MFD. Even when it was working fine, I felt it was not running at full RPM revolutions per minute. My friend suggested that replacing old capacitor with 4 MFD will help resolve RPM...
How do I change a capacitor in ceiling fan?
[ 6 Answers ]
I have a Hampton Bay Huntington III ceiling fan that is only 7 months old. The fan speed is stuck in the "high" mode. Using the pull chain doesn't change the speed. I contacted HB's helpline and was advised that it was a bad capacitor. They mailed me a new one but no instructions. How do I...
Ceiling Fan - Motor Start Capacitor
[ 2 Answers ]
I have a Hampton Bay ceiling fan whose motor fails to self-start. The fan has three speeds. All three speeds work fine if I hand spin the blades, starting at low speed of course. The fan has a remote unit. Once I hand start the fan the remote allows me to change speeds up and down and turn off the...
Ceiling fan: change capacitor for single speed
[ 3 Answers ]
I have a Loyal Products made in Taiwan fan with melted 4 wire capacitor. The capacitor has blue wire in and red 4uF, white 4.5uF and yellow 5uF wires out. This is connected to a two layer switch by the red and yellow wire. The white capacitor wire connects to a red wire going into the motor. My...
Hanging ceiling fan from vaulted ceiling peak
[ 2 Answers ]
Want to install Hampton Bay's Berlini model 729395 on a cathedral ceiling with a single ridge beam. Want to hang fan from the peak and there's not enough room for the canopy to cover the hanger bracket. Is there any extenders for this? View more questions Search
|