Not your question?
Ask your question
View similar questions
Add your answer here.Check out some similar questions!
Tips on copper compression fitting?
[ 11 Answers ]
My problem is whenever I work with coppoer compression fittings, I never seem to get a good seal and something always leaks. Are there any tips on how to do it right? Should I use a hack saw verse my Reciprocating Saw to cut the tube? (SLow vs Fast). I know the cut has to be straight, then...
Malleable/Best-fitting Outlet Covers
[ 1 Answers ]
Hello All! Would anyone be able to give me some tips/ideas/suggestions on some different types of outlet covers that work well with "rough pine log" surfaces. I have @ 20 different outlets/switches boxed within logs for a new log home and looking for some suggestions on some founded ways of dealing...
Leaded fitting in shower
[ 3 Answers ]
I'm replacing a shower.. the old pan drain is leaded to the drain pipe. How do I remove the lead? What is the easiest way to proceed? Can I do this myself, or do I need a plumber? Thanks for your help.
Removing galv fitting from cast iron pipe
[ 4 Answers ]
What is the best way to remove a threaded stuck lead fitting from a cast iron section? The fitting was from a lead sink drain pipe and it connected to the cast pipe at the toilet elbow. I tried a pipe wrench and a hammer to try to budge it but no go. I want to thread new PVC into the section of...
Retro fitting K&N FIPK Kits
[ 1 Answers ]
I want to change the stock air filter unit on my 94 dodge spirit, and perhaps put a K&N kit in it. Although K&N does not make a kit for my car, not surprisingly, I have seen some set ups that look like they would fit well under my hood. The air filter is a good size, and the pipe's bend could be... View more questions Search
|