Not your question?
Ask your question
View similar questions
Add your answer here.Check out some similar questions!
Changing from copper to plastic water lines
[ 2 Answers ]
Hi All, I am trying to move the water supply lines for the bathroom so that I can begin framing a bathroom in the basement. The water lines are going right across the bottom of the floor joists where I need to put up the headers for the walls so I need to move them. My brother in law was...
Copper into plastic
[ 2 Answers ]
Hi iwas replacing my floor because it was rotting when I was cutting some of it up I got into my copper supply line for the shower how can I tie into it with plastic because my soldering job turned out to be a big waste of time. Thank you for your help
Soldering copper pipe to shower valve
[ 10 Answers ]
I have a shower valve body (brass) and am trying to solder copper pipe to it. For the life of me I can't seem to get the pipe and fitting hot enough to melt the solder. I noticed soldering copper pipe to the drop elbow took more flame heat than normal. Is there some trick when soldering copper...
Gas valve noise on main valve engagement
[ 1 Answers ]
I have a carrier 58gs100ga furnace with a white rodgers 36e93 gas valve. The main gas valve solenoid chatters or rattles for a split second before it stays engaged after the pilot is proved. I just replace the spark/lock out board and the fan board for a different problem. This chatter is...
Plastic and Copper pipe connections
[ 1 Answers ]
Help... I am trying to replace a kitchen faucet. The copper water supply pipe is connected to a plastic shut-off valve. I want to replace the plastic shut-off valve with a metal valve. The plastic shut-off valve will not come off the copper water supply pipe. How do I get this off? I tried... View more questions Search
|