Ask Experts Questions for FREE Help !
Ask
Page 2 of 2 « First < 2
    Demianwulf's Avatar
    Demianwulf Posts: 11, Reputation: 1
    New Member
    		  
    #21

    Mar 18, 2013, 07:28 AM
    I had to run off to work after getting home, but I fired her up and she works like a charm for now. I am going to leave it running and hope it doesn't lock out again this evening. I'll take the volt meter to her this evening too. If I don't post back consider this issue resolved. Thanks for all your fine help ladies and gents. Hope this log will help the next guy/gal too with similar issues.
    mygirlsdad77's Avatar
    mygirlsdad77 Posts: 5,713, Reputation: 339
    Plumbing Expert
    		  
    #22

    Mar 18, 2013, 03:34 PM
    So it fired up okay. Good to hear. Hope the issue is resolved. Let us know if it acts up again. Thanks for the update and good luck. Take care. Lee.
    nvdragon1's Avatar
    nvdragon1 Posts: 16, Reputation: 4
    New Member
    		  
    #23

    Mar 18, 2013, 05:15 PM
    The carriers are pretty much the same as others . And there shold be nothing going to the HSI until call is made.. to be honest Ive never seen that.. All I could think is its prob a fult in a ground and or com. Sorry I can't help with that part
Not your question? Ask your question View similar questions
 
Page 2 of 2 « First < 2

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

Bryant furnace doesn't always start [ 0 Answers ]

Sometimes, when our 1997 furnace comes on, you can hear the flame "whoosh" and keep going for maybe 10 seconds, but the fan doesn't start up then. It tries again - and if all three times don't work, the furnace automatically shuts off for several hours. Lately this has been happening more than...

Bryant Furnace - IGNITOR PROBLEM! Need help! [ 4 Answers ]

I have a Bryant 383KAV. When I install the bottom panel the blower runs for about 90 seconds. Once the blower runs for 90 seconds, the inducer fan will start up and then I hear the click that would typically begin the process of heating up the Ignitor. After about 7 seconds or so, I can hear/smell...

Bryant 383KAV Furnace Ignitor will NOT get RED? [ 0 Answers ]

I have a Bryant 383KAV. When I install the bottom panel the blower runs for about 90 seconds. Once the blower runs for 90 seconds, the inducer fan will start up and then I hear the click that would typically begin the process of heating up the Ignitor. After about 7 seconds or so, I can...

383KAV Bryant Furnace - Code 14 Not getting 120 volts to ignitor [ 1 Answers ]

Still scratching my head on this one. Everything appears to be working fine on my furnace, except that the ignitor is not getting juice to glow orange/white, hence the gas is not igniting? I disconnected the ignitor harness from the control board, ran the test sequence again, and determined that I...

View more questions Search