Bending corrugated roofing sheets

Flashman2 Posts: 50, Reputation: 1

Junior Member

Dec 3, 2007, 05:31 PM

Bending corrugated roofing sheets

I have a need to bend a couple of roofing sheets at about a 12 inch radius WITHOUT using special equipment. I remember the Army using something to do the job for trenching around corners. Any help appreciated.

Check out some similar questions!

IB Roofing (pvc) vs. CertianTeed Roofing [ 3 Answers ]

Can anyone tell me the pros and cons between these two roofing materials. I am in charge of having a roof replaced for our city council. We have had several contractors come in and give us estimates and its down between these two. Both are at the same cost. This is going on a building with a flat...

Bending schedule 40 galvanised pipe [ 1 Answers ]

Is it possible to bend the schedule 40 galvanised pipe to get curve about 30-45 degrees of angle? The temperature of the water flowing in it is max 50 degrees C and the pressure is 6 bars it will be a shower connection between shower nosle and shower mixer.:mad: :mad: :confused: :mad: :confused:

Bending 1/2 " cooper pipe [ 2 Answers ]

I'm a novice do-it -yourselfer. I'm trying to replace a new shower but the new valve I purchased does not line up with the old cooper piping supply lines. It is 1/2" cooper and is off about 3/4" on either side of the fixture. Can Cooper piping be bent slighting and if so how? Thank you.

Side of TV picture bending inward [ 2 Answers ]

I have a Sony Trinitron TV that is 13 years old, I have never had a problem with it but about 2 days ago there is a black frame on the sides that is bending inward . I can still watch TV but since the sides are bent inward it elongates the people, picture and it is very annoying. Any ideas what...

View more questions Search

Check out some similar questions!

Add your answer here.