Not your question?
Ask your question
View similar questions
Add your answer here.Check out some similar questions!
How do I wire up a Marley electric baseboard heater?
[ 2 Answers ]
This is my first post, so thanks in advance for any help. I'm finishing my basement & am installing a pair of Marley electric baseboard heaters in parallel. I've got the basics done: double 20 amp breaker, 12ga wire, Double line break thermostat. Here's the issue: The units will accept left or...
Replaced electric water heater Atlanta area, but no hot water
[ 14 Answers ]
The old water heater died. Bot one (38 gals) at HD. Installed exactly like the old one was as follows--3 CPVC pipes come out of wall. Two are joined. Before they are joined one has a valve. After they are joined there is a second valve. The pipe is connected to the cold side of the heater using...
Electric water heater to pex
[ 2 Answers ]
My new hot water heater has 3/4" pipe connections, can i use a 3/4"pipe to 3/4" PEX brass adapter with an inline Pex 3/4" ball valve, or is there a reason I see some folks installing brass or bronze extensions? My pex manifold is less than 3 feet from the water heater and will use 3/4" pex line to...
Installing electric Space Heater - do I need heat resist. Wire?
[ 2 Answers ]
I'm installing a 240v, 1500 W (6.25 A) electric space heater made by: Zonal Energy Efficient Heater - Electric Wall, Fan, and Baseboard Heaters I read their installation instructions - no requirements fro wire are spelled out. Can I run regular 12/2 romex to this or do I need some type of...
What size wire for electric heater?
[ 2 Answers ]
I'm hoping someone can help with this question. We are installing an electric wall furnace, 240 volt, 38 amp, 9.2kwh. I was told by the guy at the hardware store to use size 8 wire. The instructions (?? ) that come with the unit don't sat anywhere what size is to be used! Is size 8 wire correct?... View more questions Search
|