Not your question?
Ask your question
View similar questions
Add your answer here.Check out some similar questions!
Can I run a 2 lamp fixture with a 4 lamp ballast?
[ 1 Answers ]
I recently bought some Lithonia fixtres from HD with GESB electronic ballasts. They don't Physically hum but do cause a lot of interference with FM reception. Since I do a lot Of FM tuner alignments, these were unacceptable. I phoned Lithonia (actually Accupro - the 1-800 number is right on the...
Where can I get an alien baby lamp?the xeno lamp
[ 4 Answers ]
I have been looking for the alien xeno lamp for a while I really want one bad but I can find a store or online where I can find one if you know or if you have one for sale notify me and most likely ill buy it :p
Cannot Reset Lamp Timer Following New Lamp Insatllation
[ 2 Answers ]
I replaced LCD lamp in my panasonic TV (pt-44lcx65). I get a message on my screen to reset timer and the lamp light on the front of the TV is still on. The replacement buld is a dlp (bp96-00224j). The instructions that came with the lamp refer me to the manual for timer reset and the manual refers...
Outside metal lamp casing reads hot-low voltage leaks through-troubleshooting?
[ 5 Answers ]
My mother is attached to a hard sought and found outside wall mount lamp above her garage. The metal lamp case sets off my current indicator as much as 110-120 volts do. I knew we have touched it in the past with no consiquences unknowing it was a bit hot. So the voltage leaking into it is low.... View more questions Search
|