Not your question?
Ask your question
View similar questions
Add your answer here.Check out some similar questions!
Emerson motor condenser wiring replacing 3 wire motor with 5 wire.
[ 5 Answers ]
Any recommendations? New motor apparently is capable of running in either direction by switching brown and purple wires going to the capacitor. Looks like then either the remaining brown or purple is spliced to or hooked up to the same terminal as the yellow. Thanks.
Trying to connect 12/3 wire to switch powered by 14/2 wire
[ 2 Answers ]
I am installing a ceiling fan. I ran new 12/3 wire for the fan. The existing switch in the wall is powered by 14/2. I want to run the lites off the switch and the fan with constant power. Can I tie the black source wire to my black fan wire & then pigtail that connection to the bottom screw on the...
I only have a white wire and a black wire how do I connect them to the receptacle
[ 2 Answers ]
I have 1 white wire and 1 black wire how do I connect them to the receptacle?
Where to connect the 'A' wire on a new thermostat?
[ 13 Answers ]
I have a Coleman furnace and air-conditioner unit and I want to replace the thermostat. The old one has wires connected to the 'Y', 'G', 'W', 'R' and 'A'. I can't find where to connect the wire that was connected to the 'A' terminal on the old thermostat to the new thermostat. Would anyone...
How to connect a 4 wire thermostat?
[ 1 Answers ]
I'm trying to wire a 4 wire theromostat but I need to figure out what wire goes to the right terminal. The red is power, the green is fan, but the blue and the white I not sure. The Termostat is a hunter 40035a model. The terminals on it are rh,rc with a jumper wire and g fan, y air conditioner, w... View more questions Search
|