Ask Experts Questions for FREE Help !
Ask
    Heath0423's Avatar
    Heath0423 Posts: 1, Reputation: 1
    New Member
     
    #1

    Jan 4, 2007, 09:55 AM
    Lennox Heat Pump
    I have a Lennox Heat Pump & Furnace. It is 7 years old and I have have 2 recent repairs on the system. This past August, the heat/cool valve was replaced because it was leaking freon. In November the control board in the furnace was replaced because the blower wouldn't come on to supply heat. Now, with the outside temperature averaging 45 degrees, the Heat Pump is supplying cooler than usual heat causing the aux heat (gas) to come on more than usual to heat the house. The thermostat is set to heat and 74 degrees.

    James

Check out some similar questions!

NO HEAT! Janitrol heat pump and AC system. Changing to Lux Thermostat. Wiring issue. [ 11 Answers ]

I have a Janitrol A/C and heat pump system. I replaced the thermostat with a Lux T9000LC The A/C works fine, but the heater does not. I have it wired as follows: G - Green Y - Yellow W - White RH - Pink B -

Electric Heat-Pump-No heat [ 2 Answers ]

I had a wall-mounted unit installed in a room in may of this summer. In the middle of the night the heat shut off and has not come back on since. It is an Amana, electric heat with heat pump unit. The cooling works, the heating setting does not blow air at all. When I remove the cover it says...

Lennox heat pump makes noise, slow condenser fan [ 1 Answers ]

Lennox, 20r-48 heat pump ac, roof mount in Phoenix, AZ outside temp 30-65 deg f. My heat pump makes a howl noise from the condenser fan and the fan speed is slow. Condenser coils frost outside but I haven't looked at the coils this time of the year in the past due to no need, (good performance and...

Heat pump vs electric heat [ 3 Answers ]

I have a heat pump with a two stage thermostat, 1st stage is heat pump, 2nd stage is electric (resistance) heat. Is it ever more economical to run the furnace with resistance heat only, not the heat pump? I know that the outdoor temperature affects the ability of the heat pump to work, but is...

Lennox Heat Pump [ 1 Answers ]

I have a Lennox heat pump. I have measured 220VAC to the bottom of the compressor contactor. However, when I turn the thermostat to cool the blower fan comes on but the outside compressor is not energized. I can manually engage the contactor and the compressor and cooling fan come on. I can't...


View more questions Search
 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.