Ask Experts Questions for FREE Help !
Ask
    thomas1937's Avatar
    thomas1937 Posts: 1, Reputation: 1
    New Member
    		  
    #1

    Jun 12, 2008, 05:31 PM
    murray drive belt
    Can any one tell me how to install the drive belt on a murray 30 in riding mower, [ model 30546x49] and the routing of it.

    Thanks Tom
    CliveC's Avatar
    CliveC Posts: 7, Reputation: 1
    New Member
    		  
    #2

    Jul 27, 2008, 02:36 AM
    For a diagram try using the ordertree.com website - as for fitting it the - I've found the only hard part is getting it onto the pulley wheel(s) at the point(s) where there is a metal piece to stop the belt coming off and at each point like this make sure you have some slack in the belt to the left of the belt stop - then angle the belt so that the portion to the left side of the belt stop is at the same height as the pulley wheel - and the right side is just above the pulley wheel (this will happen anyway because of the stiffness of the belt etc.) - then pull the belt (in a left to right direction) and you will find that the belt will gradually feed into the pulley wheel vee while going past the belt stop. OK ?
Not your question? Ask your question View similar questions
 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

Need a Murray Automatic Drive 17 HP 42" Belt Diagram [ 8 Answers ]

I need help bad! I have a 2002 Murray Riding Lawnmower 17 HP 42". I broke a belt and do not know how to put the new one back on. I need a belt diagram for the two belts at the top of the mower, not the deck with the one long belt. The model # 425303x92 I tried to put it back on and no luck. Any...

1997 Murray riding mower drive belt [ 4 Answers ]

I have a 1997 17hp Murray riding mower with 42" cut. My drive belt has broken and I cannot read the part number. I was never given a manuel for this mower so I have no idea what to get. The model number is 42536x92A. If someone out there can help me I would certainly appreciate it a lot.

Murray lawnmower drive belt installation [ 2 Answers ]

I have murray 15.5hp 40" cut tecumseh engine riding mower engine model ohv155 204503c dom 7014 s and I need installation instructions for the drive belt. And a belt, pully diagram

How to replace murray drive belt [ 2 Answers ]

I have a Murray self propelled lawn mower and I need instructions on how to replace the drive belt. It is model number 20615x92A. Thank you.

Murray 14 hp 42" cut Blade Drive Belt Loose [ 3 Answers ]

What are ways of tightening the blade drive belt on a Murray Model 42813A Riding lawn mower with a 42" wide cut? Just installed new one & blades will turn while mower is stationary, but will stop while trying to run over any grass?

View more questions Search