Ask Experts Questions for FREE Help !
Ask
    handsfull's Avatar
    handsfull Posts: 1, Reputation: 1
    New Member
     
    #1

    Apr 18, 2008, 02:16 AM
    Can a solid oak floor be float installed on top of concrete?
    Greetings,

    I have 20 square meters of 3/4 inch solid French oak flooring in 5 or 6 inch width. I have trolled the web pages looking for advice as to whether this material can be installed in the floating manner on top of a concrete sub floor. The opinions vary widely. Can this be done?
    Clough's Avatar
    Clough Posts: 26,677, Reputation: 1649
    Uber Member
     
    #2

    Apr 18, 2008, 02:33 AM
    From what I have read, I think that it can be done. I also think that you might find the information on the following site helpful to you.

    Installing Hardwood Floors -- Over Concrete Slabs
    amricca's Avatar
    amricca Posts: 851, Reputation: 92
    Senior Member
     
    #3

    Apr 18, 2008, 06:57 AM
    It can be done but you need to put plywood down first which will cause a total floor build-up of 1 1/2". A floating floor is better for a slab.
    ballengerb1's Avatar
    ballengerb1 Posts: 27,378, Reputation: 2280
    Home Repair & Remodeling Expert
     
    #4

    Apr 18, 2008, 07:19 AM
    Is this a basement or above grade slab? Moisture is your enemy with solid wood, a vapor barrier and nailing surface are needed. Floating floor may work for laminates but not full thickness oak tongue and groove.
    ac101's Avatar
    ac101 Posts: 463, Reputation: 57
    Full Member
     
    #5

    Apr 18, 2008, 01:39 PM
    I have to go with ballenger on this one the 3/4 oak is going to have to be nailed to something and a vapor barrier is definitley needed you might be able to install plywood and then install the floor but the height might be too much. Also if you have a basement or a slab below grade I wouldn't even try it. Either way don't try to just float the 3/4 I seriously doubt it would hold up at all.
    gsr5uh's Avatar
    gsr5uh Posts: 1, Reputation: 1
    New Member
     
    #6

    Apr 28, 2008, 05:53 PM
    Hi I am a flooring specialist and no please do not glue down solid wood on concrete or wood. The correct material to use would be an engineered that would be layered for stability, can be floated or glued on concrete. Floated needs a vapor barrier like used with laminate.
    mike jones 1269's Avatar
    mike jones 1269 Posts: 17, Reputation: 2
    New Member
     
    #7

    May 8, 2008, 07:29 PM
    Solid wood needs to be nail together over wood sub floor it is to unstable as a floating floor also try to put some of the wood together in a open area check to see how warped it is then ask yourself do you really want to sit there and hold every joint together until the glue dries

Not your question? Ask your question View similar questions

 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

Converting a tile floor to a stained concrete floor [ 2 Answers ]

I am thinking about taking up the tile in my kitchen and staining the concrete underneath it, but I don't know if it will be possible to get up all the stains left on the concrete from the tile. I do not want to take up the tile if there is too much of a possibility that the tile stains won't come...

Concrete floor pricing [ 4 Answers ]

Hi.. am planning on setting concrete floor on my yard that is 1000 sq ft. in La, CA.there is no grass or concrete only soil but is pretty much level ineed an stimate with material and labor or just material please help!! Thanks ahead Bdlr

Floor Tile, Concrete floor is sealed. [ 1 Answers ]

I want to replace carpet with tile on concrete floor but concrete is sealed with some coating. Do I have to prime this or remove sealant?

Best concrete to use to level floor? [ 1 Answers ]

Hello, I covered a concrete patio and am now is used as a sunroom. The room is 10' by 10' and slopes 2". I would prefer to have a level floor. I see there are self leveling products but I don't think that is necessary as I can trowel concrete no problem. Is it OK to us basic concrete without...

Raising a floor drain in concrete floor [ 2 Answers ]

I have an old concrete floor with a newer pvc type drain. The floor slopes about 1.5" over 2' around the drain so I would like to raise the drain in order to level the floor to install ceramic tiles. I'm still going to ensure the floor slopes toward the drain just enough. I figure I need to...


View more questions Search