Ask Experts Questions for FREE Help !
Ask
    salemi1's Avatar
    salemi1 Posts: 1, Reputation: 1
    New Member
    		  
    #1

    Aug 12, 2007, 06:39 AM
    Removing riding mower blade
    I am unable to remove my mower blade on my craftsman riding mower LT1000.
    I removed the top nut but I am unsure if I knock down the shaft with a hammer or take it off another way please help so I can sharpen my mower blades.
    Thank you
    mike
    MOWERMAN2468's Avatar
    MOWERMAN2468 Posts: 3,214, Reputation: 243
    Ultra Member
    		  
    #2

    Aug 12, 2007, 09:02 AM
    If you took off the top nut, put it back on. To remove the blade you will remove the nut on the bottom side of the blade.
    MOWERMAN2468's Avatar
    MOWERMAN2468 Posts: 3,214, Reputation: 243
    Ultra Member
    		  
    #3

    Aug 12, 2007, 09:03 AM
    If you have no way to get the unit up high enough and safely enough to get an impact wrench underneath, use a block of wood to wedge between the blade and mower deck housing to "hold" the blade while you loosen the nut.
    weby's Avatar
    weby Posts: 2, Reputation: 1
    New Member
    		  
    #4

    Apr 5, 2008, 10:13 PM
    I am not sure if the cutting blade nut can be removed by counter clock wise or not
    MOWERMAN2468's Avatar
    MOWERMAN2468 Posts: 3,214, Reputation: 243
    Ultra Member
    		  
    #5

    Apr 6, 2008, 07:25 AM
    Quote Originally Posted by weby
    I am not sure if the cutting blade nut can be removed by counter clock wise or not
    On most of the "smaller" yard equipment the old rule of thumb, "Righty tighty, Lefty loosey" does apply. The bolt may just be seized a little. The bolts tend to tighten up more the longer they are in use. Secure the blade tightly and next time perhaps you will better understand what you are doing and it will go better for you.
Not your question? Ask your question View similar questions
 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

Weedeater Riding Mower, Blade won't engage [ 2 Answers ]

We have a Weedeater riding lawnmower model 733-848 or HD12538j. The blade will not engage and I found a spring that fell out. I can't tell by the manual where it goes.

17.5 Murray riding mower 3 blade deck belts [ 5 Answers ]

I have this riding mower and need to know the # for the blade engage belt. The one on there is too big..

Sears Craftsman Riding Lawn Mower Blade adjustment [ 1 Answers ]

My Sears Craftsman 42" cut riding lawnmower has 2 blade decks. With the height adjustment lever in the highest position (or in any position), the left blade/deck cuts lower than the right. How do I adjust the left blade deck/blade to a higher position?l

Removing engine on murray riding mower [ 1 Answers ]

I have a Murray riding mower. The engine was vibrating and it took me awhile but found two screws missing. I put two back in but engine still vibrate. Further investigation showed that the holes in the engine plate had reemed out and the screws were not holding the engine steady. My question: I...

View more questions Search