Air gap around sleeved copper bus bars

muruganandam Posts: 1, Reputation: 1

New Member

Apr 4, 2008, 02:04 AM

Air gap around sleeved copper bus bars

How much should be the minimum air gap between copper bus bars and the nearby contactor

robkelly2242 Posts: 57, Reputation: 0

Junior Member

Apr 5, 2008, 08:23 PM

It depends on the voltage in the bus bar,

Add your answer here.

Check out some similar questions!

Do I need to add air tubes or air hammer arresters on sink and toilet copper plumbing [ 12 Answers ]

I noticed in some houses being built nearby that where they stubbed the copper pipe out for the sink they also ran a stub up about a foot and put a cap on it. I'm assuming it's to prevent water hammer or something. Do I need to do the same thing for my copper in my finished basement or can I just...

Copper bus panels in Southern California - Do they Exist? [ 5 Answers ]

I'm getting ready to install a whole new electrical service in my home. I really want a 200 amp meter/load center combo panel with a copper bus, and a 200 amp subpanel with a copper bus. BUT, it's almost as if copper bus panels aren't sold in this part of the country. So far I've tried: - Home...

Air Gap, yes or no? [ 4 Answers ]

My name is Sherrie McIntyre and I live in Washington State. I have a home that was built in 1952. I am replacing the drain pipes under my sink after removing a non-working, non-repairable dishwasher. It was an under the sink model and we will not be replacing it at this time. I discovered that...

Air Gap is overflowing [ 3 Answers ]

Hi All I have a very baffling situation. We changed our countertop, now the air-gap is overflowing for the first few seconds every time the dishwasher empties and makes a mess on the counter top, then continues to drain normally. Here is the setup. THREE separate drains under the sink, each...