 |
|
| Browse | Ask | Answer | Search | Join/Login |
|
|
||||
|
Wiring for Honeywell RTH230B
I have a 3 wire zoned heating system, and trying to install the Honeywell RTH230B programmable thermostat. I removed an old Honey well thermostat and the terminals so old I couldn't make out the terminal identifiers. Currently I have 4 wires exposed in my wall Red Yellow Black Green. Can someone tell me where on the terminals for my thermostat I should be placing these wires.
Currently I have them set as follows Red on RH Heating power supply Jumper between RhRc Heating Power Supply and Cooling Power Supply Green on G terminal Fan Black on W terminal Heating signal |
||||
|
||||
|
((I have a 3 wire zoned heating system)) ARE you talking about the number of wires on the zone valve? Because you stated you have 4 thermostat wires to start with.
If you have hot water heat with 3 wire zone valves the thermostat you have will not work. For all other systems here is your manual. http://customer.honeywell.com/techli...0s/69-1800.pdf The instructions said to label/identify the wires on the old thermostat for placement on the new thermostat. Since you could not identify the terminals on the old thermostat it will be nothing but a guessing game from here. You will have to track down each wire from the thermostat to where they land in the furnace terminal strip then see where they go and what they operate from there, Then after you find out that you will be able to refer to the new thermostat wiring locations. Sorry but that is the reason for identifying the wires on the old thermostat. |
||||
| Question Tools | Search this Question |
Add your answer here.
Check out some similar questions!
I'm trying to install a rth230B, but my wiring connection choices do not match up with my current T-stat wires. Note: My current digital T-stat is a power sharing model (ie. no batteries) and the rth230b uses batteries, so I have that difference right out of the box. I have a single stage gas...
I'm trying to install a rth230B, but my wiring connection choices do not match up with my current T-stat wires. Note: My current digital T-stat is a power sharing model (ie. no batteries) and the rth230b uses batteries, so I have that difference right out of the box. I have a single stage gas...
The wiring out of my wall for my thermostat is Blue, Red, Green, Yellow, and white My old nonprogrammable thermostat's wiring was connected by C (blue),R (red),G(green),Y(Yellow),W(white) My new Honeywell RTH230B has connections for Rh, Rc, G, Y, W
I'm installing the rth230b on a 3 wire gas fired boiler. The wires are blue, red, white. On the old mercury stat the blue and red wre on the same post. Anybody know how I should wire this one? Thanks! Mike
I have an existing Honeywell non-programmable thermostat with 2 wires, a white and black. I 'd like to replace with the RTH230B programmable. After reading the Reader's Digest Do-it-Yourself book, it says I would need to add wires if I wanted to replace a non-programmable thermostat with a...
View more questions Search
|
