Ask Experts Questions for FREE Help !
Ask
    jkules's Avatar
    jkules Posts: 1, Reputation: 1
    New Member
     
    #1

    Mar 25, 2008, 11:04 AM
    Kitchen and Bath Exhaust Vents
    We recently purchased a new-construction home. After two months, with the strong winds blowing, our exhaust vents from the bathroom and the kitchen are constantly making a banging noise---as if the vent covers are beating against the vent.

    Is there a fix for this? Our builder told us "that's just the way it is." I have lived in numerous single-family homes over the past 50 years in all parts of the country and the world and NEVER have had a problem like this.

    Do we need a new/different exhaust vent on the roof?

    Is there a vent flap (or vent unit) inside the house from the kitchen (stove/micorwave) and bathroom that could be improved on?

    Thanks.

    Jack
    hvac1000's Avatar
    hvac1000 Posts: 14,540, Reputation: 435
    Heating & Air Conditioning Expert
     
    #2

    Mar 25, 2008, 11:58 AM
    The builder should have picked a better location for your vent termination. The real cure is to move the vent discharge pipes from where they terminate now to a location where the wind is not so strong. Usually there are one or two locations on every house that the vent can be placed so the wind will not blow back the vent and into the house.

    Vents have dampers and that is what you hear banging around as the wind buffets the damper.

Not your question? Ask your question View similar questions

 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

How far apart do fresh air and exhaust vents need to be [ 2 Answers ]

Hi I have a reehm 90+ furnace, I was told the fresh air and exaust vent were installed wrong. They currently are a 2" pipe inside a 3" fresh air. I need to raise it about 2' because it is too low to ground and snow plugs it. So would like to vent it right when I move it. At furnace it has 2-2"...

Bathroom and kitchen exhaust fan vents [ 5 Answers ]

I have a 290 cfm remote, 4 port bath exhaust fan serving two bathrooms. The exhaust port is 6 inches in diameter. I will be installing a 360 cfm range hood exhausting to 6 inch pipe. Can I join both kitchen and bath exhaust pipes in the attic and have the exhaust for both run out the same...

Bathroom and kitchen exhaust fan vents [ 1 Answers ]

Bathroom and kitchen exhaust fan vents -------------------------------------------------------------------------------- I have a 290 cfm remote, 4 port bath exhaust fan serving two bathrooms. The exhaust port is 6 inches in diameter. I will be installing a 360 cfm range hood exhausting to...

Kitchen exhaust - gas stove [ 1 Answers ]

Hello, I have a gas stove located on an interior wall. Is it a safe practice to run the ducting from the interior wall, down into the basement (4 foot), and turn 90 degrees to duct outside (8 foot)? My thought is to mount the motor/fan in the basement at the exterior wall location. Do you...


View more questions Search