Not your question?
Ask your question
View similar questions
Add your answer here.Check out some similar questions!
Bad Furnace Control Board?
[ 6 Answers ]
I have a Carrier 58PAV that intermittently aborts or sometimes clicks on and off at the draft blower stage. I found out I can move the control board (HK42FZ007) when the blower motor clicks off, and it clicks and comes right back on. If I hold it just right, the furnace starts and if I manage to...
Coleman furnace 6 wires to blower
[ 3 Answers ]
HELP! I was going to start my furnace for the first time this season, and went to do my annual cleaning. Problem is as I was taking out blower (to take outside and clean out) I accidentally dropped and the 6 wires running between the blower and furnace came undone. I don't want to hook it up...
Wires running from furnace
[ 3 Answers ]
Hi - I need some help please. My furnace is in my garage - there are 2 brown covered wires running from the bottom part of the furnace toward the ceiling and into the wall to my house. A stray cat got into the garage and was sitting on top of my hot water tank and I noticed that one of the wires...
Identiying Wires on for Furnace on Thermostat
[ 1 Answers ]
I have a Honeywell Thermosat, model RTH6300B, and I want to know which wires that I connect to the termostat are the wires for the furnace. In short, if I disconnect the thermostat to test the furnace by starting it directly, which ones are the furnace wires that I should connect. I also have...
Power to furnace control board but stops there
[ 3 Answers ]
Hi I was given a Nordyne KG6RA gas furnace. After installing, I turned on and there was a low hum when the power got to it. I held the door switch closed so I could see. After a few seconds there was a spark and then blue smoke and everything went dead. I could not see where the smoke came... View more questions Search
|