 |
|
|
 |
New Member
|
|
Mar 8, 2008, 08:46 AM
|
|
Furnace runs then shuts off too early
My forced air furnace will run for around 5 minutes. Then it will stop but the servo motor will keep running. After another 5 minutes it will fire back up, the fan will kick in and it will start pushing heat. Then it will stop again some times within seconds, sometimes minutes. Does this sound like a High limit switch? If so is there a way to test it? I have put two new thermostats in with no change to the problem.
Thanks
|
|
 |
Heating & Air Conditioning Expert
|
|
Mar 8, 2008, 09:30 AM
|
|
Servo motor
What is a servo motor?
|
|
 |
New Member
|
|
Mar 8, 2008, 09:58 AM
|
|
Hi, I'm not sure of the name of the motor but it's the blower that runs before the main blower and before the burners ignite.
Thanks
|
|
 |
Ultra Member
|
|
Mar 8, 2008, 06:25 PM
|
|
It's a good chance the main limit is tripping out. Is your return air filter clean and all of your supply grills open? How old is your furnace and what brand is it? The info will help a lot. The small motor is called the inducer motor or vent motor.
|
|
 |
New Member
|
|
Mar 8, 2008, 07:31 PM
|
|
Hi the filter is clean and the grill is also. The brand is "4runner" by Goettl. It's about 10 yrs old. If I jumper the hi limit switch it automatically starts the furnace. Is this right?
Thanks for your help.
|
|
 |
Ultra Member
|
|
Mar 8, 2008, 08:33 PM
|
|
If it works when you jump the high limit you have a air flow problem or bad limit(YOU DO NOT WANT TO BYPASS THE LIMIT AND LET IT GO). I'm not familiar with that system but they all use about the same way of making them work and faulting out.
|
|
 |
New Member
|
|
Mar 9, 2008, 06:51 PM
|
|
I'll try to get a limit switch for it and give that a try.
Thanks for your advice!
|
|
 |
New Member
|
|
Jan 4, 2010, 03:24 PM
|
|
Hi mother has an intertherm furnace and it will run fine diring the day but late at night it starts cycling on and off and t stat blinks flinter on and off.
|
|
 |
Heating & Air Conditioning Expert
|
|
Jan 4, 2010, 03:57 PM
|
|
Please start a new post for your question.
|
|
Question Tools |
Search this Question |
|
|
Add your answer here.
Check out some similar questions!
92' Civic Runs Fine, but intermittently shuts off.
[ 78 Answers ]
So here's the deal. A couple weeks ago my civic just shut off and would not start again. I went through and gave it a full tune-up. (spark plugs, wires, filters, cap & rotor) I ended up solving the problem when I replaced the Ignition Control Module and Coil. I also had some bad gas that had water...
Furnace shuts down early
[ 1 Answers ]
I have a "Day & Night" gas heating/air 5 ton unit. When I turn on the heat in the morning all works fine but the unit shuts down before the desired temp. It's not the thermostat because I know enough to go out to the unit and bypass the thermostat. Nothing happens. After an hour or so, the unit...
Murray runs 1/2 hour then shuts off
[ 2 Answers ]
I just bought a used 19' murry lawn mower, the first time I used it it ran for about 1/2 an hour and shuts off, I found if I turn it on its side and push the primer button, it will run a few more minutes but then again shuts off. Can somebody help me.:confused:engine type=briggs and stratton, hp=4...
View more questions
Search
|