Ask Experts Questions for FREE Help !
Ask
    tbettyplummer's Avatar
    tbettyplummer Posts: 1, Reputation: 1
    New Member
     
    #1

    Mar 7, 2008, 08:18 AM
    Clog in 'cable operated' vanity sink
    I have a slow drain in an American Standard bathroom vanity sink. The stopper is cable operated. I can disconnect the cable, but I still cannot pull the stopper out of the sink. I tried twisting the stopper right or left to disconnect it, but that doesn't work either. How can I get the stopper out so I can clear the clog ?
    amricca's Avatar
    amricca Posts: 851, Reputation: 92
    Senior Member
     
    #2

    Mar 7, 2008, 08:31 AM
    There is a rod with a ball on it that is holding the stopper in place / moving it up and down, that is what the cable was attached to. You have to remove the pivot nut from under the sink to remove the stopper. Should be above the trap, toward the back. Remove and clean out the trap while you are down there, should help with the slow drain unless the clog is further in than that. Take alook at this site, the picture shows the pivot nut.

    Bathroom Sink Popup and Stopper Problems from the Natural Handyman Home Repair and Do It Yourself website
    speedball1's Avatar
    speedball1 Posts: 29,301, Reputation: 1939
    Eternal Plumber
     
    #3

    Mar 8, 2008, 08:36 AM
    Quote Originally Posted by tbettyplummer
    I have a slow drain in an American Standard bathroom vanity sink. The stopper is cable operated. I can disconnect the cable, but I still cannot pull the stopper out of the sink. I tried twisting the stopper right or left to disconnect it, but that doesn't work either. How can I get the stopper out so I can clear the clog ?
    If the stopper won't pull up then the installer tied it down. To free the stopper, push down on the knob raising the stopper to the drain position. Now go underneith the lavatory and locate a knured nut with a rod sticking out of it. Take a pair of pliers and free the nut just enough for it to turn by hand. STOP! Now hand loosen the nut enough so the nut and rod just begains to clear. STOP!
    Now GENTLY, while you're pulling up on the stopper pull the nut and rod out SLOWLY and STOP when the stopper clears enough to remove. CAREFUL! Don't let it pull all the way out. Now tighten the nut by hand and snug it up with a pair of pliers. You may now just drop the stopper in and it will continue to ride on top of the rod so if you ever have to remove it you can.
    Hope this helps . Tom
    rookieplumbr's Avatar
    rookieplumbr Posts: 1, Reputation: 1
    New Member
     
    #4

    Nov 18, 2011, 12:07 PM
    Try doing a search for the American Standard sink's installation instructions.
    http://m.americanstandard-us.com/assets/documents/amstd/install/Install_1264.pdf
    I have a new home and all three sinks have these newfangled cable pop-up systems and they are junk in my opinion. After 2 months all of the pop-ups don't work.
    Like these guys say, you have to loosen that nut under the sink where the pop-up cable connects to. Then carefully remove the cam that is in there by prying it out with a flat screwdriver from the side of it. If you can get that out, then you SHOULD be able to free the stopper.

Not your question? Ask your question View similar questions

 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

No clog - super slow draining bathroom sink [ 3 Answers ]

A little while ago I wanted to change the faucet in my bathroom. I bought new taps and it came with a pop-up drain cover so I changed that out and replaced an old chrome P-trap with plastic. The old sink setup was working fine - I just didn't like the taps. When I re-connected everything, the sink...

Vanity Sink trap [ 4 Answers ]

I'm installing a bathroom sink with very little clearance to place the trap below the waste pipe. Will this present a problem draining water or causing gas fumes? There will also be extra bends involved. Please refer to my sketch. Thanks. Jay

Replacing single sink vanity [ 3 Answers ]

I'm replacing my single sink vanity with a double sink vanity. Can I use the water supply lines that were for the single sink for the 2 new sinks. What do I use to supply both sinks?

New sink causing drain problems, not from clog [ 3 Answers ]

I just had a shop sink installed about six feet away from my kitchen sink. The guy who did it insisted it would work but now the kitchen sink does not drain well at all, nor does the shop sink. Here's the setup. The kitchen sink has a trap and then the pipe goes down almost to the floor and then...

Kitchen sink drain clog [ 1 Answers ]

My kitchen sink drain has a complete clog. I have a dual tub sink with a disposal on the left and the dishwasher drain on the right. The water backs up into the sink regardless of which tub I run the water into. It also backs up into both sinks when I run the dishwasher. This tells me the...


View more questions Search