Ask Experts Questions for FREE Help !
Ask
    tuanwa's Avatar
    tuanwa Posts: 1, Reputation: 1
    New Member
    		  
    #1

    Mar 2, 2008, 12:07 PM
    Gas furnace prob: only 1/2 of the vents work
    I have a York gas forced air furnace. The air comes out of the vents in lower floor of the house just fine. However, all the vents upstairs, you can barely feel any air coming out. I would appreciate any advice.

    Thanks!
    big countrycane's Avatar
    big countrycane Posts: 3, Reputation: 1
    New Member
    		  
    #2

    Mar 2, 2008, 12:39 PM
    Quote Originally Posted by tuanwa
    I have a York gas forced air furnance. The air comes out of the vents in lower floor of the house just fine. However, all the vents upstairs, you can barely feel any air coming out. I would appreciate any advice.

    Thanks!
    Check your duct work to see if there may be a disconnected duct between the unit and your outlets or may be something restricting air flow.
Not your question? Ask your question View similar questions
 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

Gas furnace won't ignite. [ 1 Answers ]

I have an Inter-City furnace and I installed an electronic thermostat. The furnace pilot will ignite, but when I turn the gas valve from pilot to (on) and turn the thermostat to ( heat), the furnace doesn't come on.

Why gas furnace won't burn? [ 1 Answers ]

I set the thermostat to heat as usual and the furnace does come on and ignites then Quickly turns off. Only the blower continues to run. The furnace is only 10 years old.

Gas furnace [ 1 Answers ]

My Furnace will run for about 12 hours no problem then all of a sudden the pilot light will go out , for the past two days its done this.. It stopped at about 5.30 am then last night at about 1.30pm... I will go down and relight it and it will start right up... It blows hot air seems fine... ...

Gas furnace Outside Fixture [ 5 Answers ]

I'm wondering what options I have for outside supply and discharge? The appliance is a high efficiency York NG furnace (small, less than 60K BTU.). The installation manual shows what could just be PVC elbows. I'm wondering if there are other options. The furnace is intended as backup...

View more questions Search