Ask Experts Questions for FREE Help !
Ask
    novaman's Avatar
    novaman Posts: 21, Reputation: 4
    New Member
    		  
    #1

    Feb 29, 2008, 09:31 AM
    Buick 3.8 Harmonic Balancer
    It's ready to pull, so I can get to the crank sensor. Bolt out etc.

    It has a 3 small slots for a puller to get into. Well I have an assortment of 3 jaw pullers 3" being the smallest. No way!!

    Do you guys have one that has a part number I can get one?? Do they make a 2" or what?
    Snap On wasn't much help either so that's why I asking .

    Any tips, ideas etc.
    CaptainRich's Avatar
    CaptainRich Posts: 4,492, Reputation: 537
    Cars & Trucks Expert
    		  
    #2

    Feb 29, 2008, 01:33 PM
    GM buys their's from Kent-Moore.
    Part # J 38197 Crankshaft Balancer Puller
    You can find that here:
    Kent-Moore - ToolSource - 30,000 automotive tools online. Fast Delivery, Friendly service, Secure on-line ordering.
    novaman's Avatar
    novaman Posts: 21, Reputation: 4
    New Member
    		  
    #3

    Mar 1, 2008, 05:54 AM
    Thanks. I tried something like that from Lisle.
    Another board member said OTC 6267. By the pictures it may work.

    Today after work going to hunt one of these down and try it.
    Will let you know...
    novaman's Avatar
    novaman Posts: 21, Reputation: 4
    New Member
    		  
    #4

    Mar 1, 2008, 07:05 PM
    It worked decent. The arms were a bit larger than the holes so had to grind a little. Not much though.

    Replacing that sensor was a pain. Adjustable using a non-metallic feeler gauge. YEA RIGHT.
    No room at all...

    It runs again that's all that matters.
Not your question? Ask your question View similar questions
 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

Harmonic motion [ 2 Answers ]

A vertical sprng with spring stiffness constant 305N/m vibrates with an amplitude of 28.0cm when 0.260kg hangs from it. The mass passes through the equilibrium point(y=0) with positive velocity at t=0 a) What equation describes this motion as a function of time? b) At what times will the spring...

Harmonic motion [ 1 Answers ]

A 0.60 kg mas vibrates according to the equation x= 0.45cos6.40r, where x is in meters and t is in seonds. Determinr a) the amplitude b) the frequency c) the total energy and d) the kinetic energy and potential energies when x=0.30m.

Harmonic motion [ 1 Answers ]

The springs of a 1500kg car compress 5.0mm when its 68kg driver gets into th drivers seat. If the car goes over a bump what will bethe frequency of vibrations?

Harmonic motion [ 1 Answers ]

At what dissplacement from equilibrium is the speed of a SHO half the maximum value?

Harmonic balancer [ 3 Answers ]

How do I get the harmonic balancer off my ford ranger, to replace it?

View more questions Search